Specifications

.9 Disc Skip
This selects a disc in a selected zone.
If the unit receives this command while in playback or a pause, the unit completes disc selection and becomes
ready to play back, then continues to run according to its immediately previous state the unit plays only 1 track.
bytebit 7 6 5 4 3 2 1 0
0
STX 02h
1
Command code T
2
Skip code Forward Reverse Direct D
3
Disc number ( 100 digits )
4
Disc number ( 10 digits )
5
Disc number ( 1 digit )
6
ETX 03h
7
BCCH high-level
8
BCCL low-level
Answers returned
bytebit 7 6 5 4 3 2 1 0
0
STX 02h
1
Reply code T
2
Answer code
3
ETX 03h
4
BCCH high-level
5
BCCL low-level
Special conditions
· Disc number parameters ( Byte 3-5 ) are effective only when the skip code is D .
· It is canceled the disc or the track specified under PLAY command. It should send the
command after this command to reserve the next disc or the track.
· This command is valid only when the zone status is Play (F) or PAUSE (G).
· The unit can skip to a maximum disc with Forward (+) and to a minimum disc with Reverse (–
) and when it goes to more than those discs, the Order Disc None (3) answer code is issued.
· This command is ignored when a disc specified by a skip code "+" or "-" of this command is
used in the other zone in the multi-zone mode.
Other