User's Guide

3
Connections Playback Troubleshooting
ENGLISH
Specications
Index
Cautions on Handling
• Do not get ngerprints, oil or dirt on discs.
• Take special care not to scratch discs when removing them from
their cases.
• Do not bend or heat discs.
• Do not enlarge the hole in the center.
• Do not write on the labeled (printed) surface with ball-point pens,
pencils, etc., or stick new labels on discs.
• Water droplets may form on discs if they are moved suddenly from
a cold place (outdoors for example) to a warm place, but do not try
to dry them off using a hairdryer, etc.
Cautions on Storing Discs
• Be sure to remove discs after using them.
• Be sure to store discs in their cases to protect them from dust,
scratches, warping, etc.
• Do not store discs in the following places:
1. Places exposed to direct sunlight for long periods of time
2. Dusty or humid places
3. Places exposed to heat from heaters etc.
Cleaning Discs
• If there are ngerprints or dirt on a disc, wipe them off before using
the disc. Fingerprints and dirt can impair sound quality and cause
interruptions in playback.
• Use a commercially available disc cleaning set or a soft cloth to
clean discs.
Gently wipe the disc from the
inside towards the outside.
Do not wipe in a circular
motion.
NOTE
Do not use record spray, antistatic agents, benzene, thinner or other
solvents.
Getting Started
• “TRACK0 0m00s” is displayed if a disc that cannot be played is
loaded.
• “NO DISC” is displayed if the disc is loaded upside-down or if no
disc is loaded.
Cautions on Loading Discs
• Only load one disc at a time. Loading two or more discs can damage
the unit or scratch the discs.
• Do not use cracked or warped discs or discs that have been repaired
with adhesive, etc.
• Do not use discs on which the sticky part of cellophane tape or
labels is exposed or on which there are traces of where labels have
been removed. Such discs can get caught inside the player and
damage it.
• Place the disc in the tray, label side up.
• Make sure the disc tray is fully open when inserting the disc.
• Place the discs at 12 cm discs in the outer tray guide (Figure 1), 8
cm discs in the inner tray guide (Figure 2).
Loading Discs
• Place 8 cm discs in the inner tray guide without using an adapter.
NOTE
Do not push the disc tray in by hand when the power is turned off.
Doing so could damage the set.
Inserting the Batteries
q Remove the rear cover of the
remote control.
w Set two R03/AAA batteries in
the battery compartment in the
indicated direction.
e Put the rear cover back on.
NOTE
• Replace the batteries with new ones if the set does not operate
even when the remote control is operated close to the unit.
• The supplied batteries are only for verifying operation.
• Insert the batteries in the proper direction, following the “q” and
“w” marks in the battery compartment.
• To prevent damage or leakage of battery uid:
• Do not use a new battery with an old one.
• Do not use two different types of batteries.
• Do not attempt to charge dry batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries in a
re.
• If the battery uid leaks carefully wipe the uid off the inside of the
battery compartment and insert new batteries.
• Remove the batteries from the remote control if it will not be used
for a long time.
• Dispose of batteries in accordance with local regulations on battery
disposal.
About the Remote Control
Figure 1
12 cm disc 8 cm disc
Figure 2
Outer tray guide Inner tray guide
Discs
1.DCD-A100_E3_ENG_001.indd 3 2010/08/30 19:27:28