Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Features
- Table of Contents
- Panel Lock Function
- Video Comversion
- Supplied Accessories
- Parts & Controls
- Connections
- Cables Used for Connection
- Speaker Installation / Placement
- Connecting Speakers
- Subwoofer
- About Cable Labels
- Speaker Configuration and Amp Assign Settings
- Bi-Amp Connection
- Multi-Zone Speakers
- TV
- Playback Devices
- USB Device
- Antennas
- Home Network
- Connecting an External Control Device
- Zone 2 / Zone 3 Connections
- Power Cord
- Playback
- Power On
- Selecting the Input Source
- Volume / Mute
- Playing a Blu-ray / DVD Player
- USB Device
- Bluetooth
- FM / AM Radio
- Internet Radio
- Playing Back Files Stored On a PC and NAS
- Getting the HEOS App
- AirPlay
- Spotify Connect
- Convenience Functions
- Adding to HEOS Favorites
- Playing back HEOS Favorites
- Deleting a HEOS Favorites
- Adjusting the Audibility of Dialog and Vocals (Dialog Enhancer)
- Adjusting the Volume of each Channelto Match the Input Source (Channel Level Adjust)
- Adjusting the Tone (Tone)
- Displaying your Desired Video During Audio Playback (Video Select)
- Adjusting the Picture Quality for your Viewing Environment (Picture Mode)
- Playing the Same Music in All Zones (All Zone Stereo)
- Selecting a Sound Mode
- HDMI Control Function
- Smart Menu Function
- Sleep Timer
- Quick Select Plus Function
- Panel Lock Function
- Remote Lock Function
- Web Control Function
- Playback in ZONE 2 / ZONE 3
- Settings
- About HDMI
- Relationship Between Video Signals and Monitor Output
- Personal Memory Plus
- Last Function Memory
- Sound Modes and Channel Output
- Sound Modes and Surround Parameters
- Types of Input Signals and Corresponding Sound Modes
- Glossary
- Tips
- Troubleshooting
- Specs
- Index
- Quick Start Guide
- Microphone Stand Assembly Instructions
- Speaker Wire Labels
- IMAX DTS Firmware Update Information
- Spotify
- Warranty
Error messages
An error message is displayed if Audyssey
®
Setup could not be completed due to speaker placement, the measurement environment, etc. If an error
message is displayed, check the relevant items and perform the necessary measures. Be sure to turn off the power before checking speaker connections.
Examples Error details Measures
No speakers found.
0
Sound calibration microphone is not
detected.
0
Connect the included Sound calibration microphone to the
SETUP MIC jack of this unit.
0
Not all speakers could be detected.
0
Check the speaker connections.
Ambient noise is too high or level is too
low
0
There is too much noise in the room.
0
Either turn off any device generating noise or move it away.
0
Perform again when the surroundings are quieter.
0
Speaker or subwoofer sound is too low.
0
Check the speaker installation and the direction in which the
speakers are facing.
0
Adjust the subwoofer’s volume.
Front R : None
0
The displayed speaker could not be
detected.
0
Check the connections of the displayed speaker.
Front R : Phase
0
The displayed speaker is connected with the
polarity reversed.
0
Check the polarity of the displayed speaker.
0
For some speakers, this error message may be displayed
even if the speaker is properly connected. If you are sure the
connection is correct, press p to select “Ignore”, then press
ENTER.
Contents Connections Playback Settings Tips Appendix
217
Front panel Display Rear panel Remote Index