Owner's Manual
Table Of Contents
- Quick Start Guide
- Owners Manual
- Reset
- Features
- Table of Contents
- Video Conversion Function
- Supplied Accessories
- Parts & Controls
- Connections
- Playback
- Power On
- Selecting the Input Source
- Volume / Mute
- Playing a Blu-ray / DVD Player
- USB Device
- Bluetooth
- FM / AM Radio
- Internet Radio
- Playing Back Files Stored On a PC and NAS
- Getting the HEOS App
- AirPlay
- Spotify Connect
- Convenience Functions
- Adding to HEOS Favorites
- Playing back HEOS Favorites
- Deleting a HEOS Favorites
- Adjusting the Volume of each Channel to Match the Input Source (Channel Level Adjust)
- Adjusting the Tone (Tone)
- Displaying Your Desired Video During Audio Playback (Video Select)
- Adjusting the Picture Quality for your Viewing Environment (Picture Mode)
- Playing the Same Music in All Zones (All Zone Stereo)
- Selecting a Sound Mode
- HDMI Control Function
- Smart Menu Function
- Sleep Timer
- Quick Select Plus Function
- Playback in ZONE2
- Settings
- About HDMI
- Video Conversion Function
- Personal Memory Plus
- Last Function Memory
- Sound Modes and Channel Output
- Sound Modes and Surround Parameters
- Types of Input Signals and Corresponding Sound Modes
- Glossary
- Tips
- Troubleshooting
- Specs
- Index
- Spec Sheet
- Warranty
Bass
Set subwoofer and LFE signal range playback.
o
Subwoofer Mode
Select low range signals to be reproduced by subwoofer.
LFE
(Default):
The low range signal of the channel set to
“Small” speaker size is added to the LFE
signal output from the subwoofer.
LFE+Main:
The low range signal of all channels is
added to the LFE signal output from the
subwoofer.
0
“Subwoofer Mode” can be set when “Speaker Config.” - “Subwoofer” on the
menu is set to other than “No”. (v p. 186)
0
Play music or a movie source and select the mode offering the strongest bass.
0
If “Speaker Config.” - “Front” and “Center” are set to “Large”, and “Subwoofer
Mode” is set to “LFE”, no sound may be output from the subwoofers,
depending on the input signal or selected sound mode. (v
p. 185)
Select “LFE+Main” if you want the bass signals to always be produced from
the subwoofer.
o
LPF for LFE
Set LFE signal playback range. Set this when you want to change the
playback frequency (low pass filter point) of the subwoofer.
80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 200 Hz / 250 Hz
(Default: 120 Hz)
Contents Connections Playback Settings Tips Appendix
193
Front panel Display Rear panel Remote Index