Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Video Conversion
- Supplied Accessories
- Parts & Controls
- Features
- Connections
- Cables used for connections
- Speaker installation
- Connecting speakers
- Connecting a subwoofer
- About the cable labels
- Speaker configuration and “Amp Assign” settings
- Connecting a TV
- Connecting a playback device
- Connecting a USB memory device
- Connecting an FM/AM antenna
- Connecting to a home network
- Connecting an external control device
- Zone 2 Connections
- Connecting the power cord
- Playback
- Basic operation
- Playing a USB memory device
- Listening to music on a Bluetooth device
- Listening to FM/AM broadcasts
- Listening to Internet Radio
- Playing back files stored on a PC or NAS
- Getting the HEOS App
- AirPlay function
- Spotify Connect function
- Convenience functions
- Selecting a sound mode
- HDMI control function
- Smart Menu function
- Sleep timer function
- Quick select plus function
- Playback in ZONE2
- Settings
- Tips
- Troubleshooting
- Resetting factory settings
- Resetting network settings
- Personal memory plus function
- Last function memory
- Sound modes and channel output
- Sound modes and surround parameters
- Types of input signals, and corresponding sound modes
- Glossary
- Specs
- Index
- Quick Start Guide
- Microphone Stand Assembly Instructions
- Spec Sheet
- Speaker Wire Labels
- HEOS
- Spotify
- Warranty
0
The wireless LAN (Wi-Fi) settings of this unit can also be configured from a PC or
tablet that supports wireless LAN connection.
1. Press and hold the DIMMER and STATUS buttons on the main unit for at least 3
seconds when the power of the unit is on.
2. Connect the wireless LAN of the PC or tablet used to “Denon AVR-X2400H”
when the message “Connect your Wi-Fi device to Wi-Fi network called “Denon
AVR-X2400H”” appears in the display.
3. Start up the browser and enter “192.168.1.16/Settings/” in the URL.
4. Use the browser to enter the settings, select “Connect” and then exit the
settings.
0
The Default key of this unit is fixed at “1”. Set Default key of the router to “1” to use.
Settings
Configure the IP address.
0
If you are using a broadband router (DHCP function), the information
required for network connection such as the IP address will be
automatically configured since the DHCP function is set to “On” in the
default settings of this unit.
0
Set up the IP Address, Subnet Mask, Default Gateway and DNS server
information only when assigning a fixed IP address or when connecting
to a network without DHCP function.
.
DHCP
-IP Address
-Subnet Mask
Save
Cancel
-Default Gateway
-DNS
Configures the network settings automatically or manually
Off
Network/Settings
000.000.000.000
000.000.000.000
000.000.000.000
000.000.000.000
Contents
Connections Playback Settings Tips Appendix
193
Front panel Display Rear panel Remote Index