Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Video Conversion
- Supplied Accessories
- Parts & Controls
- Features
- Connections
- Cables used for connections
- Speaker installation
- Connecting speakers
- Connecting a subwoofer
- About the cable labels
- Speaker configuration and “Amp Assign” settings
- Connecting a TV
- Connecting a playback device
- Connecting a USB memory device
- Connecting an FM/AM antenna
- Connecting to a home network
- Connecting an external control device
- Zone 2 Connections
- Connecting the power cord
- Playback
- Basic operation
- Playing a USB memory device
- Listening to music on a Bluetooth device
- Listening to FM/AM broadcasts
- Listening to Internet Radio
- Playing back files stored on a PC or NAS
- Getting the HEOS App
- AirPlay function
- Spotify Connect function
- Convenience functions
- Selecting a sound mode
- HDMI control function
- Smart Menu function
- Sleep timer function
- Quick select plus function
- Playback in ZONE2
- Settings
- Tips
- Troubleshooting
- Resetting factory settings
- Resetting network settings
- Personal memory plus function
- Last function memory
- Sound modes and channel output
- Sound modes and surround parameters
- Types of input signals, and corresponding sound modes
- Glossary
- Specs
- Index
- Quick Start Guide
- Microphone Stand Assembly Instructions
- Spec Sheet
- Speaker Wire Labels
- HEOS
- Spotify
- Warranty
Network
To use this unit by connecting it to a home network (LAN), you must configure network settings.
If you set up your home network (LAN) via DHCP, set “DHCP” to “On”. (Use the default setting.) This allows this unit to use your home network (LAN).
When assigning an IP address to each device manually, you need to assign an IP address to this unit using the “IP Address” settings, and enter
information about your home network (LAN) such as the gateway address and subnet mask, etc.
Information
Display network information.
Friendly Name / Connection / SSID / DHCP / IP Address /
MAC Address (Ethernet) / MAC Address (Wi-Fi) /
Wi-Fi signal strength
Connection
Choose whether to connect the home network to a wireless LAN or a
wired LAN.
When connecting to the network using wired LAN, select “Wired
(Ethernet)” after connecting a LAN cable,
When connecting to the network using wireless LAN, select “Wireless (Wi-
Fi)” and configure the “Wi-Fi Setup”. (v
p. 191)
o
Connect Using
Select the method for connecting to the home network (LAN).
Wired (Ethernet): Use a LAN cable to connect to a network.
Wireless (Wi-Fi)
(Default):
Use the wireless LAN (Wi-Fi) function to
connect to a network.
Contents Connections Playback Settings Tips Appendix
190
Front panel Display Rear panel Remote Index