Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Video Conversion
- Supplied Accessories
- Parts & Controls
- Features
- Connections
- Cables used for connections
- Speaker installation
- Connecting speakers
- Connecting a subwoofer
- About the cable labels
- Speaker configuration and “Amp Assign” settings
- Connecting a TV
- Connecting a playback device
- Connecting a USB memory device
- Connecting an FM/AM antenna
- Connecting to a home network
- Connecting an external control device
- Zone 2 Connections
- Connecting the power cord
- Playback
- Basic operation
- Playing a USB memory device
- Listening to music on a Bluetooth device
- Listening to FM/AM broadcasts
- Listening to Internet Radio
- Playing back files stored on a PC or NAS
- Getting the HEOS App
- AirPlay function
- Spotify Connect function
- Convenience functions
- Selecting a sound mode
- HDMI control function
- Smart Menu function
- Sleep timer function
- Quick select plus function
- Playback in ZONE2
- Settings
- Tips
- Troubleshooting
- Resetting factory settings
- Resetting network settings
- Personal memory plus function
- Last function memory
- Sound modes and channel output
- Sound modes and surround parameters
- Types of input signals, and corresponding sound modes
- Glossary
- Specs
- Index
- Quick Start Guide
- Microphone Stand Assembly Instructions
- Spec Sheet
- Speaker Wire Labels
- HEOS
- Spotify
- Warranty
Error messages
An error message is displayed if Audyssey
®
Setup could not be completed due to speaker placement, the measurement environment, etc. If an error
message is displayed, check the relevant items and perform the necessary measures. Be sure to turn off the power before checking speaker connections.
Examples Error details Measures
No speakers found.
0
Sound calibration microphone is not
detected.
0
Connect the included Sound calibration microphone to the
SETUP MIC jack of this unit.
0
Not all speakers could be detected.
0
Check the speaker connections.
Ambient noise is too high or level is too
low
0
There is too much noise in the room.
0
Either turn off any device generating noise or move it away.
0
Perform again when the surroundings are quieter.
0
Speaker or subwoofer sound is too low.
0
Check the speaker installation and the direction in which the
speakers are facing.
0
Adjust the subwoofer’s volume.
Front R : None
0
The displayed speaker could not be
detected.
0
Check the connections of the displayed speaker.
Front R : Phase
0
The displayed speaker is connected with the
polarity reversed.
0
Check the polarity of the displayed speaker.
0
For some speakers, this error message may be displayed
even if the speaker is properly connected. If you are sure the
connection is correct, press p to select “Ignore”, then press
ENTER.
Contents Connections Playback Settings Tips Appendix
177
Front panel Display Rear panel Remote Index