Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Video Conversion
- Supplied Accessories
- Parts & Controls
- Features
- Connections
- Cables used for connections
- Speaker installation
- Connecting speakers
- Connecting a subwoofer
- About the cable labels
- Speaker configuration and “Amp Assign” settings
- Connecting a TV
- Connecting a playback device
- Connecting a USB memory device
- Connecting an FM/AM antenna
- Connecting to a home network
- Connecting an external control device
- Zone 2 Connections
- Connecting the power cord
- Playback
- Basic operation
- Playing a USB memory device
- Listening to music on a Bluetooth device
- Listening to FM/AM broadcasts
- Listening to Internet Radio
- Playing back files stored on a PC or NAS
- Getting the HEOS App
- AirPlay function
- Spotify Connect function
- Convenience functions
- Selecting a sound mode
- HDMI control function
- Smart Menu function
- Sleep timer function
- Quick select plus function
- Playback in ZONE2
- Settings
- Tips
- Troubleshooting
- Resetting factory settings
- Resetting network settings
- Personal memory plus function
- Last function memory
- Sound modes and channel output
- Sound modes and surround parameters
- Types of input signals, and corresponding sound modes
- Glossary
- Specs
- Index
- Quick Start Guide
- Microphone Stand Assembly Instructions
- Spec Sheet
- Speaker Wire Labels
- HEOS
- Spotify
- Warranty
8
Move the Sound calibration microphone to position 2,
select “Continue”, then press ENTER.
The measurement of the second position starts.
Measurements can be made in up to eight positions.
.
Continue
Place the microphone ear level of the listener seated at the
2nd listening position, which should be no more than 2ft
(60cm) away from the 1st position, then select “Continue”...
Audyssey Setup
Back
Ear Height
n
Stopping Audyssey
®
Setup
A
Press BACK to display the popup screen.
B
Press o to select “Yes”, then press ENTER.
9
Repeat step 8, measuring positions 3 to 8.
0
To skip measuring the fourth and subsequent listening position, press o to
select “Complete” and press ENTER to proceed to step 11.
10
Select “Continue”, then press ENTER.
.
Audyssey Setup
Continue
Repeat Last Test
Measurements complete.
Select “Continue” to analyze the data...
Start the analysis and storage of the measurement results.
0
Analysis takes several minutes to complete.
The more speakers and measurement positions that there are,
the more time it takes to perform the analysis.
NOTE
0
When the measurement results are being saved, make sure the power is
not turned off.
Contents Connections Playback Settings Tips Appendix
174
Front panel Display Rear panel Remote Index