Owner's Manual

158
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
Distances
Set distance from listening position to speakers.
Measure beforehand the distance from the listening position to each
speaker.
2 Unit
Set the unit of distance.
Feet (Default)
Meters
2 Step
Set the minimum variable width of the distance.
1ft (Default) / 0.1ft
0.1m / 0.01m
2 Set Defaults
The “Distances” settings are returned to the default settings.
2 Set the distance
0.0ft – 60.0ft / 0.00m – 18.00m
%
•The speakers that can be selected dier depending on the “Amp Assign”
(vpage155) and “Speaker Config.” (vpage156) settings.
•Default settings :
Front L / Front R / F. Height L / F. Height R / Center / Subwoofer : 12.0 ft (3.60
m)
Surround L / Surround R / Surr.Back L / Surr.Back R : 10.0 ft (3.00 m)
•Set the dierence in the distance between the speakers to less than 20.0 ft
(6.00 m).
Levels
Set the volume of the test tone to be the same when it is output from
each speaker.
2 Test Tone Start
Output test tone. A test tone is output from the selected speaker.
While listening to the test tone, adjust the volume output from the
selected speaker.
–12.0dB – +12.0dB (Default : 0.0dB)
%
•When “Levels” is adjusted, the adjusted values are set for all the sound
modes.
•When headphones are connected to the PHONES connector on this unit, you
cannot set “Levels”.
2 Set Defaults
The “Levels” settings are returned to the default settings.