Owner's Manual
Table Of Contents
- Getting Started Guide
- Owners Manual
- Reset
- Table of Contents
- Features
- Video Conversion Function
- Supplied Accessories
- Parts & Controls
- Connections
- Playback
- Power On
- Selecting the Source
- Volume / Mute
- Playing a DVD Player / Blu-ray Disc Player
- iPod Playback
- USB Device Playback
- Tuner Operation
- Internet Radio
- Playing Back Files Stored on a PC and NAS
- Viewing Photographs on the Flickr Site
- Listening to Pandora
- Listening to SiriusXM Internet Radio
- Listening to Spotify
- Adding to the FAVORITE STATION Button
- AirPlay
- Convenience Functions
- All Zone Stereo
- Selecting a Sound Mode
- HDMI Control Function
- Sleep Timer Function
- Quick Select Function
- Web Control Function
- Playback in ZONE 2
- Settings
- Specifying the Zone Used with the Remote Control Unit
- Tips
- Troubleshooting
- About HDMI
- Video Conversion Function
- Types of Input Signals and Corresponding Sound Modes
- Glossary
- Specs
- Index
- Scan of CD-ROM
- Adhesive Labels
- Warranty
153
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
Error messages
An error message is displayed if Audyssey® Setup could not be completed due to speaker placement, the measurement environment, etc. If an error
message is displayed, check the relevant items and perform the necessary measures. Be sure to turn o the power before checking speaker connections.
Examples Error details Measures
Microphone or Speaker is
None
•Setup and measurement microphone is not
detected.
•Not all speakers could be detected.
•Connect the included Setup and measurement microphone to the
SETUP MIC jack of this unit.
•Check the speaker connections.
Ambient noise is too high or
level is too low
•There is too much noise in the room.
•Speaker or subwoofer sound is too low.
•Either turn o any device generating noise or move it away.
•Perform again when the surroundings are quieter.
•Check the speaker installation and the direction in which the
speakers are facing.
•Adjust the subwoofer’s volume.
Front R : None •The displayed speaker could not be
detected.
•Check the connections of the displayed speaker.
Front R : Phase •The displayed speaker is connected with
the polarity reversed.
•Check the polarity of the displayed speaker.
•For some speakers, this error message may be displayed even if
the speaker is properly connected. If you are sure the connection is
correct, use p to select “Skip Error”, then press ENTER.