Owner's Manual

149
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
3
Connect the Setup and measurement microphone to
the SETUP MIC jack of this unit.
Audyssey Setup
Channel Select
Amp Assign
Check Results
Restore...
Start
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
When the Setup and measurement
microphone is connected, the
following screen is displayed.
4
Select “Start” and then press ENTER.
Audyssey® Setup can also make the following settings.
•Amp Assign
The signal output from the SURROUND BACK speaker terminals
of this unit can be switched to match your speaker environment.
Refer to “Amp Assign” (vpage155).
•Channel Select
If channels that are not to be used are set in advance,
measurement for the set channels is skipped, and measuring
time can be reduced. You can also change the number of surround
back speakers.
5
Select “Next” and then press ENTER.
6
Select “Begin Test” and then press ENTER.
•Measurement requires several minutes.
NOTE
•If “Caution!” is displayed on TV screen:
Go to “Error messages” (vpage 153). Check any related items, and
perform the necessary procedures.
When measuring has stopped
q Press BACK to display the popup screen.
w Press o to select “Yes”, and then press ENTER.