Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Supplied Accessories
- Parts & Controls
- Features
- Connections
- Cables used for connections
- Speaker installation
- Connecting speakers
- Connecting a subwoofer
- About the cable labels
- Speaker configuration and “Amp Assign” settings
- Connecting a TV
- Connecting a playback device
- Connecting a USB memory device
- Connecting an FM/AM antenna
- Connecting to a home network
- Connecting an external control device
- Zone 2 Connections
- Connecting the power cord
- Playback
- Basic operation
- Playing a USB memory device
- Listening to music on a Bluetooth device
- Listening to FM/AM broadcasts
- Listening to Internet Radio
- Playing back files stored on a PC or NAS
- Getting the HEOS App
- AirPlay function
- Spotify Connect function
- Convenience functions
- Selecting a sound mode
- HDMI control function
- Smart Menu function
- Sleep timer function
- Quick select plus function
- Playback in ZONE2
- Settings
- Tips
- Troubleshooting
- Resetting factory settings
- Resetting network settings
- Personal memory plus function
- Last function memory
- Sound modes and channel output
- Sound modes and surround parameters
- Types of input signals, and corresponding sound modes
- Glossary
- Specs
- Index
- Quick Start Guide
- Microphone Stand Assembly Instructions
- Spec Sheet
- Speaker Wire Labels
- Warranty
5
Select “Start”, then press ENTER.
Audyssey
®
Setup can also make the following settings.
0
Amp Assign
The signals output from the SURROUND BACK speaker
terminals can be switched in accordance with your speaker
environment. (“Amp Assign” (v p. 175))
0
Channel Select
If channels that are not to be used are set in advance,
measurement for the set channels is skipped, and measuring
time can be reduced. You can also change the number of
surround back speakers.
0
Dolby Sp.Setup
Set the distance between the Dolby Atmos Enabled speaker and
the ceiling.
This can be set when “Assign Mode” is set to “Front Dolby” or
“Surround Dolby” in the “Amp Assign” settings. (v
p. 175)
6
Follow the instructions on the screen display and press
“Next” to proceed further.
7
When the following screen is displayed, select “Begin
Test” and then press ENTER.
Start the measurement of the first position.
.
Select “Begin Test” to Start the Calibration.
NOTE:You will hear a series of loud test tones
starting and stopping during the tests.
Ear Height
Begin TestBack
Audyssey Setup
0
Measurement requires several minutes.
NOTE
0
If “Caution!” is displayed on TV screen:
0
Go to “Error messages” (v p. 173). Check any related items, and
perform the necessary procedures.
Contents Connections Playback Settings Tips Appendix
168
Front panel Display Rear panel Remote Index