Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Features
- Table of Contents
- Supplied Accessories
- Parts & Controls
- Connections
- Playback
- Power On
- Selecting the Input Source
- Volume / Mute
- Playing a Blu-ray / DVD Player
- USB Device
- Bluetooth
- FM / AM Radio
- Internet Radio
- Playing Back Files Stored On a PC and NAS
- Getting the HEOS app
- AirPlay
- Spotify Connect
- Convenience Functions
- Adding to HEOS Favorites
- Playing back HEOS Favorites
- Deleting a HEOS Favorites
- Adjusting the Volume of Each Channel to Match the Input Source (Ch Level Adjust)
- Adjusting the Tone (Tone)
- Displaying Your Desired Video During Audio Playback (Video Select)
- Playing the Same Music in All Zones (All Zone Stereo)
- Selecting a Sound Mode
- HDMI Control Function
- Smart Menu Function
- Sleep Timer
- Quick Select Plus Function
- Playback in ZONE2
- Settings
- Limiting the Operating Zone with the Remote Control
- About HDMI
- Personal Memory Plus
- Last Function Memory
- Sound Modes and Channel Output
- Sound Modes and Surround Parameters
- Types of Input Signals and Corresponding Sound Modes
- Glossary
- Tips
- Troubleshooting
- Specs
- Index
- Quick Start Guide
- Microphone Stand Assembly Instructions
- Spec Sheet
- Speaker Wire Labels
- Spotify
- HEOS
- Warranty
DTS sound is not output.
0
Check that the digital audio output setting on the connected device is set to “DTS”.
Dolby Atmos, Dolby TrueHD, DTS-HD, Dolby Digital Plus audio is not output.
0
Make HDMI connections. (v p. 52)
0
Check the digital audio output setting on the connected device. On some devices, “PCM” is set by default.
DTS Neural:X mode cannot be selected.
0
DTS Neural:X cannot be selected when using the headphones.
Dolby Surround mode cannot be selected.
0
Dolby Surround cannot be selected when using the headphones.
Audyssey MultEQ
®
, Audyssey Dynamic EQ
®
and Audyssey Dynamic Volume
®
cannot be selected.
0
These cannot be selected when you have not performed Audyssey
®
Setup. (v p. 159)
0
Switch to a sound mode other than “Direct”. (v p. 108)
0
These cannot be selected when using the headphones.
“Restorer” cannot be selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
surround, “Restorer” cannot be used. (v p. 138)
0
Switch to a sound mode other than “Direct”. (v p. 108)
No sound is output when using ZONE2.
0
Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL/COAXIAL) cannot be played back. Use analog connections.
0
When listening to audio from a Bluetooth device in ZONE2, remove any obstructions between the Bluetooth device and this unit and use it within a
range of about 98.4 ft/30 m.
Contents
Connections Playback Settings Tips Appendix
206
Front panel Display Rear panel Remote Index