Owner's Manual
Table Of Contents
- Quick Start Guide
- Owners Manual
- Reset
- Bluetooth PIN (0000)
- Features
- Table of Contents
- Supplied Accessories
- Parts & Controls
- Connections
- Playback
- Power On
- Selecting the Input Source
- Volume / Mute
- Playing a Blu-ray / DVD Player
- iPod Playback
- USB Device
- Bluetooth
- FM / AM Radio
- Internet Radio
- Playing Back Files Stored On a PC and NAS
- Pandora
- SiriusXM
- AirPlay
- Spotify Connect
- Convenience Functions
- Performing Repeat Playback
- Performing Random Playback
- Registering to Favorites
- Playing Back Content Added to the “Save to Favorite”
- Deleting Content Added to Favorites
- Searching Content with Keywords (Text Search)
- Playing Back Music and a Favorite Picture at the Same Time (Slideshow)
- Setting the Slideshow Interval
- Adjusting the Volume of Each Channel to Match the Input Source (Ch Level Adjust)
- Adjusting the Tone (Tone)
- Displaying Your Desired Video During Audio Playback (Video Select)
- Playing the Same Music in All Zones (All Zone Stereo)
- Selecting a Sound Mode
- HDMI Control Function
- Smart Menu Function
- Sleep Timer
- Quick Select Plus Function
- Playback in ZONE2
- Settings
- About HDMI
- Personal Memory Plus
- Last Function Memory
- Sound Modes and Channel Output
- Sound Modes and Surround Parameters
- Types of Input Signals and Corresponding Sound Modes
- Glossary
- Tips
- Troubleshooting
- Specs
- Index
- Microphone Stand Assembly Instructions
- Spec Sheet
- Speaker Wire Labels
- DTS:X Ready Information
- Firmware Update Information
- Spotify
- Warranty
Symptom Cause / Solution Page
DTS Neural:X mode cannot
be selected.
0
DTS Neural:X cannot be selected when using the headphones.
－
Dolby Surround mode
cannot be selected.
0
Dolby Surround cannot be selected when using the headphones.
－
Audyssey MultEQ
®
,
Audyssey Dynamic EQ
®
and Audyssey Dynamic
Volume
®
cannot be
selected.
0
These cannot be selected when you have not performed Audyssey
®
Setup.
168
0
Switch to a sound mode other than “Direct”.
118
0
These cannot be selected when using the headphones.
－
“Restorer” cannot be
selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of
multichannel signals such as Dolby Digital or DTS surround, “Restorer” cannot be used.
149
0
Switch to a sound mode other than “Direct”.
118
No sound is output when
using ZONE2.
0
Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL/COAXIAL)
cannot be played back. Use analog connections.
－
0
When listening to the audio of a Bluetooth device in ZONE2, remove any obstructions between the
Bluetooth device and this unit and use it within a range of about 32.8 ft/10 m.
－
Contents Connections Playback Settings Tips Appendix
215
Front panel Display Rear panel Remote Index