Owner's Manual
Table Of Contents
- Quick Start Guide
- Owners Manual
- Reset
- Bluetooth PIN (0000)
- Features
- Table of Contents
- Supplied Accessories
- Parts & Controls
- Connections
- Playback
- Power On
- Selecting the Input Source
- Volume / Mute
- Playing a Blu-ray / DVD Player
- iPod Playback
- USB Device
- Bluetooth
- FM / AM Radio
- Internet Radio
- Playing Back Files Stored On a PC and NAS
- Pandora
- SiriusXM
- AirPlay
- Spotify Connect
- Convenience Functions
- Performing Repeat Playback
- Performing Random Playback
- Registering to Favorites
- Playing Back Content Added to the “Save to Favorite”
- Deleting Content Added to Favorites
- Searching Content with Keywords (Text Search)
- Playing Back Music and a Favorite Picture at the Same Time (Slideshow)
- Setting the Slideshow Interval
- Adjusting the Volume of Each Channel to Match the Input Source (Ch Level Adjust)
- Adjusting the Tone (Tone)
- Displaying Your Desired Video During Audio Playback (Video Select)
- Playing the Same Music in All Zones (All Zone Stereo)
- Selecting a Sound Mode
- HDMI Control Function
- Smart Menu Function
- Sleep Timer
- Quick Select Plus Function
- Playback in ZONE2
- Settings
- About HDMI
- Personal Memory Plus
- Last Function Memory
- Sound Modes and Channel Output
- Sound Modes and Surround Parameters
- Types of Input Signals and Corresponding Sound Modes
- Glossary
- Tips
- Troubleshooting
- Specs
- Index
- Microphone Stand Assembly Instructions
- Spec Sheet
- Speaker Wire Labels
- DTS:X Ready Information
- Firmware Update Information
- Spotify
- Warranty
Procedure for speaker settings
(Audyssey
®
Setup)
.
Finish
Check
Calculation & Store
Measurement
Preparation
1
Attach the Sound calibration microphone to the
supplied microphone stand or own tripod and install it
at the main listening position.
When installing the Sound calibration microphone, point the tip of
the microphone toward the ceiling and adjust the height to match the
height of the ears of a listener in a seated position.
2
If using a subwoofer capable of the following
adjustments, set up the subwoofer as shown below.
n
When using a subwoofer with a direct mode
Set the direct mode to “On” and disable the volume adjustment
and crossover frequency setting.
n
When using a subwoofer without a direct mode
Make the following settings:
0
Volume : 12 o’clock position
0
Crossover frequency : Maximum/Highest Frequency
0
Low pass filter : Off
0
Standby mode : Off
Contents Connections Playback Settings Tips Appendix
170
Front panel Display Rear panel Remote Index