Owner's Manual
Table Of Contents
- Quick Start Guide
- Owners Manual
- Reset
- Bluetooth PIN (0000)
- Features
- Table of Contents
- Supplied Accessories
- Parts & Controls
- Connections
- Playback
- Power On
- Selecting the Input Source
- Volume / Mute
- Playing a Blu-ray / DVD Player
- iPod Playback
- USB Device
- Bluetooth
- FM / AM Radio
- Internet Radio
- Playing Back Files Stored On a PC and NAS
- Pandora
- SiriusXM
- AirPlay
- Spotify Connect
- Convenience Functions
- Performing Repeat Playback
- Performing Random Playback
- Registering to Favorites
- Playing Back Content Added to the “Save to Favorite”
- Deleting Content Added to Favorites
- Searching Content with Keywords (Text Search)
- Playing Back Music and a Favorite Picture at the Same Time (Slideshow)
- Setting the Slideshow Interval
- Adjusting the Volume of Each Channel to Match the Input Source (Ch Level Adjust)
- Adjusting the Tone (Tone)
- Displaying Your Desired Video During Audio Playback (Video Select)
- Playing the Same Music in All Zones (All Zone Stereo)
- Selecting a Sound Mode
- HDMI Control Function
- Smart Menu Function
- Sleep Timer
- Quick Select Plus Function
- Playback in ZONE2
- Settings
- About HDMI
- Personal Memory Plus
- Last Function Memory
- Sound Modes and Channel Output
- Sound Modes and Surround Parameters
- Types of Input Signals and Corresponding Sound Modes
- Glossary
- Tips
- Troubleshooting
- Specs
- Index
- Microphone Stand Assembly Instructions
- Spec Sheet
- Speaker Wire Labels
- DTS:X Ready Information
- Firmware Update Information
- Spotify
- Warranty
TV Format
Set the video signal format to be output for the TV you are using.
o
Format
NTSC
(Default):
Select NTSC output.
PAL: Select PAL output.
0
“Format” can also be set by the following procedure. However, the menu
screen is not displayed. Following the display content to make the setting.
1. Press and hold the main unit’s TUNER PRESET CH + and TUNE + at the
same time for at least 3 seconds.
“V.Format:<NTSC>” appears on the display.
2. Use the main unit’s TUNER PRESET CH + or TUNER PRESET CH - and
set the video signal format.
3. Press the main unit’s STATUS to complete the setting.
NOTE
0
When a format other than the video format of the connected TV is set, the
picture will not be displayed properly.
Contents Connections Playback Settings Tips Appendix
163
Front panel Display Rear panel Remote Index