Operating instructions
3
Select the play mode
Example: Stereo
STEREO
T3
(Man umt) vhlmte Control UnItI
l In the DTS mode
4
Start playback on the selected component.
l For operating instructions, refer to the component’s
manual.
5
Adjust the volume.
m MASTER”GLLM~
The volume level is displayed
on the master vokme level
display.
Figures of 0.5 d6 and below
are rounded down.
.% The volume can be adjusted within the range of -80 to 0 to 18 dB.
in steps of 0.5 dB. However, when the channel level is set as
described on page 24 or page 48, if the volume for any channel is
set at +I dB or greater, the volume cannot be adjusted up to 18
dB. (In this case the maximum volume adjustment range is “18 dB
- (Maximum value of channel level)“.)
Input mode when playing DTS sources
l Noise will be output if DTScompatible CDs or LDs are plaved in the
“ANALOG” or “PCM” mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to “AUTO” or “DTS”.
NOTE:
l The digital input indicator will light (green) when playing CD-
ROMs containing data other than audio signals, but no sound
will be heard.
Input mode display
One of these Ikghts. dependlny on the
Input SIgnal
l In the AUTO mode
-‘NP”TMEHF
AUTO
Pm
0 0 0 0
l In the PCM mode
- NPUT MODE -
AUTO
KM
DTS RF
0 0 0 0
l When switched to RF in the VDP RF or AUTO mode
l In the ANALOG mode
- lNP”T MODE -
NT0 PCM
DE RF
0 0 0 0
piiiziq
Input signal display
l DOLBY DIGITAL
--INPUTSIGNAL-
LOCK Ld9oTAL 0
0 0 0
l DTS
l PCM
--INP”TSIGNAL-
LOCK DIYN c3 ALL?4
0 0 0 0
One of these Ilghls, dependmg on the
Input sgnal.
1
lOOPRO LOGIC 1
% The AL24 indicator lights when the PURE DIRECT, DIRECT or
STEREO mode is selected in the digital input mode.
% The LOCK LED lights when digital signals are being input properly.
If the LED does not light, check whether the digital input
component setup (page 29) and connections are correct and
whether the component’s power is turned on.
Ill Adjusting the sound quality (tone)
The tone control function will not work in the Direct or Home THX Cinema mode
1
Press the MODE SELECT button and select
MODE
TONE.
SELECT
The mode switches as follows each time
the MODE SELECT button is pressed:
% Only displayed when the TUNER Input is
selected.
2
Select BASS/TREBLE with the
FUNCTION knob.
I
I
41 23
40