Operating instructions

l This unit features a subwoofer peak limit control which prevents distortion and damage in the loudspeaker system by controlling the maximum
bass volume level. With this feature you may set the maximum bass level for the system.
l This feature operates with or without a subwoofer in the system.
1
At the System Setup Menu select “Subwoofer Peak Ltmit Lev.”
I
System Setup Menu
Speaker Configuration
Delay Time
2
wwlll
Switch to the Subwoofer Peak Limit Level Setting screen.
Limit Level Setting
Find The Level When
Distortion Begins.
crPeak Limiter m4:Im
Select “ON” for Peak Limiter.
4
The screen switches. Select “Setting Start”, then
a 8 * G ~~~:he”,“,eak~r system.
The screen swatches and a test noise is produced
cfl
Limit Level Setting
Find The Level When
Distortion Begins.
RPeak Limiter m4:bm
Setting Start WI
C Peak Limiter -181 1
5
*oI
Increase the master volume level until the test noise is distorted.
The test noise (bass sound) is distorted when it sounds as if the input is
excessively high (when the sound crackles).
Limit Level Setting
Turn Up The Volume
Master Vol. @ Button
When Distortion Begins
Push Enter Button.
6
lulmlm
Press the ENTER button at the point where the test noise starts sounding distorted.
The AVR-5803 automatlcally sets the subwoofer peak limit level.
This prevents future inadvertent subwoofer overload due to excessively strong bass content when the master
volume control is at a high level.
% Clear the subwoofer’s peak limit level setting by specifying “Peak Limiter” and “OFF”
28