User's Guide

84
2 Procedure for copying the “Flat” correction curve set at “Auto Setup”, then using the graphic equalizer to adjust
manually
NOTE: If the “Auto Setup” procedure has not been performed, this item is not displayed.
1
Select “Base Curve Copy”.
５−４．Ｍａｎｕａｌ ＥＱ
Ｄｅｆａｕｌｔ Ｙｅｓ
Ｂａｓｅ Ｃｕｒｖｅ Ｃｏｐｙ
Ａｄｊｕｓｔ ＣＨ Ｌ／Ｒ ＣＨ
Ｅｘｉｔ
BaseCurve Copy
*Manual EQ
CH SEL
ENTER
(Main unit) (Remote control unit)
2
The Base Curve Select screen appears when the
Cursor left button is pressed.
５−４．Ｍａｎｕａｌ ＥＱ
Ｃｕｒｖｅ： −Ｆｌａｔ−
Ｂａｓｅ Ｃｕｒｖｅ Ｃｏｐｙ？
：
Ye s
No
Copy?: No
*Base Curve
CH SEL
ENTER
(Main unit) (Remote control unit)
3
Select “Base Curve Copy?”, then press the Cursor
left button to select “Yes”.
５−４．Ｍａｎｕａｌ ＥＱ
Ｂａｓｅ Ｃｕｒｖｅ Ｃｏｐｙ？
：
Ｃｕｒｖｅ： −Ｆｌａｔ−
Ye s
No
Copy?: Yes
*Base Curve
4
Enter the setting.
The Manual EQ screen reappears.
The type of the copied correction curve is displayed
in the upper right of this screen.
５−４．Ｍａｎｕａｌ ＥＱ −Ｆｌａｔ−
Ｄｅｆａｕｌｔ Ｙｅｓ
Ｂａｓｅ Ｃｕｒｖｅ Ｃｏｐｙ
Ａｄｊｕｓｔ ＣＨ Ｌ／Ｒ ＣＨ
Ｅｘｉｔ
(Main unit)
CH SEL
ENTER
(Remote control unit)
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
(Main unit) (Remote control unit)