User's Guide

48
2-2. Setting the low frequency distribution
Set the subwoofer mode according to the speaker system being used.
Select the play mode that provides bass reproduction with body.
4
Enter the setting.
The Speaker Setup Menu reappears.
  2−2.Subwoofer Setup
 
 
 
           
 
Mode
               :
 
 
 
           THX
LFE
LFE+Main
1
Select “Subwoofer Setup” at the Speaker Setup
Menu.
Select the setting.
NOTES:
— Assignment of low frequency signal range (2-1) —
The only signals produced from the subwoofer channel are LFE signals (during playback of Dolby Digital or DTS signals) and the low
frequency signal range of channels set to “Small” in the setup menu. The low frequency signal range of channels set to “Large” are
produced from those channels.
— Subwoofer Setup (2-2) —
The subwoofer mode setting is only valid when and “Yes” is set for the subwoofer in the “2-1. Speaker Configuration” settings (see
pages 46, 47).
When the input signal is analog or a PCM signal not including LFE signals, if “LFE-THX-” is selected, the low frequency component is not
output from the subwoofer. To output the subwoofer channel, select “LFE+Main”.
CH SEL
ENTER
(Main unit) (Remote control unit)
CH SEL
ENTER
(Main unit) (Remote control unit)
Subwoofer Setup
*Speaker Setup
CH SEL
ENTER
(Main unit) (Remote control unit)
3
   
  1.Speaker Config.
  2.Subwoofer Setup
  3.Delay Time
  4.Channel Level
  5.Crossover Frequency
  6.Surround Sp Setup
  7.THX Audio Setup
  Exit
 2.Speaker Setup
Mode: LFE-THX-
*SubwooferSetup
2
Display the Subwoofer Setup screen.
CH SEL
ENTER
(Main unit) (Remote control unit)
LFE–THX– : For any channel(s) that are set to LARGE, low frequencies in that channel’s
corresponding source are directed to that loudspeaker only. Low frequencies
that are directed to the subwoofer(s) are from the program source LFE channel,
and from other channels where the speakers are set to SMALL. THX is
recommended in this play mode so that bass interference is less likely to occur
in the room.
LFE+Main : Low frequencies from speaker channels that have been set to LARGE are
reproduced from those speakers as well as from the subwoofer(s). Depending
upon the characteristics of the LARGE main speakers, this mode may provide a
more even low frequency response throughout the listening room.