User's Guide


GUI Menu Map Setup Troubleshooting
ENGLISH
Information
Quick Select Function
With this function, the currently playing input source, input mode,
surround mode, room EQ, Dynamic EQ, Dynamic Volume
settings and volume can be stored in the memory.
1
Set the input source, input mode, surround mode,
room EQ, Dynamic EQ, Dynamic Volume settings
and volume to the conditions you want to store.
2
Press and hold the desired QUICK SELECT.
Keep pressing the button until the quick select indicator lights.
Input Source Volume
Quick Select 1 DVD –40 dB
Quick Select 2 TV/CBL –40 dB
Quick Select 3 VCR –40 dB
[Quick Select Defaults]
1
Connect the HDMI to the AVR-4308CI / AVR-3808CI
with equipment compatible with the HDMI control
function.
2
Put the power on for all the equipment connected to
the HDMI.
3
Check the settings for all the equipment connected to
the HDMI and make HDMI available to them.
b Please consult the operating instructions for the connected
equipment to check the settings.
b Steps 1~3 do not have to be repeated once started.
b Carryout steps 2 and 3 should any of the equipment be plugged
out.
4
Switch the television input to the HDMI connected to
the AVR-4308CI / AVR-3808CI.
5
Switch the AVR-4308CI / AVR-3808CI input to the
HDMI input source and check if the picture from the
player is ok.
6
Put the television power on standby and check if the
AVR-4308CI / AVR-3808CI goes into standby.
Operations
Playback
QUICK SELECT
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control unit [BUTTON]
Symbols used to indicate buttons in this manual
<Illustration : AVR-4308>
• If the AVR-4308 / AVR-3808 does not work please check the
following.
•
Is the GUI menu “Manual Setup” – “HDMI Setup” – “HDMI
Control” – “Control” (
vpage 4) set to “ON”?
•
Is the GUI menu “Manual Setup” – “HDMI Setup” – “HDMI
Control” – “Control Monitor” (
vpage 4) set for the monitor
output connected to television? (AVR-4308 only)
•
Is the GUI menu “Manual Setup” – “HDMI Setup” – “HDMI
Control” – “Power Off Control” (
vpage 4) set to “ON”?
•
Is the control function used for the television HDMI properly set?
(Check the television operating instructions for details.)
•
Should any of the operations below be performed, the interlocking
function may be reset, in which case, repeat step’s 2 and 3.
•
GUI menu “Source Select” – “(input source)” – “Assign” –
“HDMI” (
vpage 5) setting has changed.
•
There is a change to the connection between the equipment and
the HDMI, or an increase in equipment.
• When not using this unit for a long period, we recommend that you
press
<POWER> to turn off (jOFF) the power.
When “Control” (vpage 4) is set to “ON”, it consumes more
standby power.
When you start to use the unit again, redo the settings in steps 2 ~
6.
QUICK SELECT<POWER>