User's Guide
GUI Menu Map Setup Information Troubleshooting
ENGLISH
<STATUS>
uio p
<SOURCE SELECT>
<TUNING PRESET>
[ TU]
[MEMO]
uiop
[A ~ G]
[ENTER]
[CHANNEL + –]
[SEARCH]
[NUMBER]
[SOURCE SELECT]
[SAT TU]
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
The strength of both the SIRIUS satellite and terrestrial signals can
be checked at GUI menu “Source Select” – “SIRIUS” – “Antenna
Aiming” (vpage 6).
Checking the SIRIUS Signal Strength
and Radio ID
1
Either turn <SOURCE SELECT> or press [SAT TU] to
select “SIRIUS”.
b When operating via the remote control unit, you cannot select
SIRIUS even by pressing
[SOURCE SELECT] to which SIRIUS has
been assigned.
2
Press <STATUS> until “SIGNAL” appears on the
display.
The display will switch as shown below, depending on the
reception conditions.
Display Status
EXCELLENT Signal strength is excellent
GOOD Signal strength is good
WEAK Signal strength is weak
NO SIGNAL No signal
3
Adjust the position of the antenna until “SIGNAL:
EXCELLENT” is shown on the display.
4
Press <STATUS> until the channel (example:
“SR001”) is displayed.
5
Press [ ] and select channel 0 (SR000).
Channel No. and Sirius ID are alternately shown on the display.
S R 0 0 0 S i r i u s ID
* * * * * * * * * * * *
b Write your own SIRIUS ID for storage use.
Sirius ID :
Sirius ID
Listening to Preset Channels
1
Press [CHANNEL + –].
A pop-up window appears.
2
Select a preset channel using [CHANNEL + –].
3
Press [ENTER].
Operation on the Main Remote control Unit
Operation on the Main Unit
Press <TUNING PRESET>, then turn <SOURCE SELECT>
to select the preset channel.
To preset other channels, repeat steps 1 to 5.
NOTE
Preset channels are erased by overwriting them.
Presetting Radio Channels
(Preset Memory)
Your favorite broadcast channels can be preset so that you can
tune them in easily. Up to 56 channels can be preset.
1
Tune in the broadcast channel you want to preset.
2
Press [MEMO].
3
Press [A ~ G] to select the block in which the channel
is to be preset.
4
Press [CHANNEL + –] or [NUMBER (1 ~ 8)] to select
the preset number.
5
Press [MEMO] again to complete the setting.
Selection is still possible if you press [0 ~ 8] after pressing [A ~ G].
Playback
(AMP mode)
[ ]
(
mode)
<Illustration : AVR-4308>