User Guide
Table Of Contents
- SAFETY PRECAUTIONS
- NOTE ON USE
- SAFETY INSTRUCTIONS
- INTRODUCTION
- TABLE OF CONTENTS
- ACCESSORIES
- 1. BEFORE USING
- 2. CAUTIONS ON INSTALLATION
- 3. CAUTIONS ON HANDLING
- 4. FEATURES
- 5. CONNECTIONS
- 6. PART NAMES AND FUNCTIONS
- 7. SETTING UP THE SYSTEM
- 8. REMOTE CONTROL UNIT
- 9. OPERATION
- 10. SURROUND
- 11. DSP SURROUND SIMULATION
- 12. LISTENING TO THE RADIO
- 13. LAST FUNCTION MEMORY
- 14. INITIALIZATION OF THE MICROPROCESSOR
- 15. TROUBLESHOOTING
- 16. ADDITIONAL INFORMATION
- 17. SPECIFICATIONS
26
Setting the multi vol. level
Set the multi pre-out output level adjustment.
1
BAND MODE
TUNING
TUNING
At the “System Setup Menu” screen, select “Multi
Vol. Level” and press the ENTER button.
2
3
BAND MODE
TUNING
TUNING
ENTER
SHIFT
Enter the setting.
The “System Setup Menu” reappears.
Select the desired settimg.
0 dB, -40 dB:
The output level is fixed at the set level and the volume can no longer be
adjusted.
Variable:
The level can be adjusted freely using the buttons on the remote control
unit.
Setting the on-screen display (OSD)
• Use this to turn the on-screen display (messages other than the menu screens) on or off.
1
BAND MODE
TUNING
TUNING
At the System Setup Menu select “On Screen Display”.
2
3
ENTER
SHIFT
BAND MODE
TUNING
TUNING
Switch to the On Screen Display screen.
Select “ON” or “OFF”.
ENTER
SHIFT