Manual

[] SURROUND
I:_ ,'J_r_lg _ I_
• Before playing with the sun }und function, be sure to use the test tones to adjust the playback level from the
different speakers This adjustment can be performed with the system setup (see page 13) or from the remote
control unit, as described below
• Adjusting with the remote control unit using the test tones is only possible in the "Auto" mode and only
effective in the DOLBY/DTS SURROUND modes The adiusted levels for the different modes are automatically
stored in the memory
Press the TEST TONE button
(Re_ lot e cot tlO! urlt!
Test tones are output from
the different speakers Use
the channel volume adjust
buttons to adiust so that the
volume of the test tones s
{Re/Iotec/r tlO!_nt) the same for all the speakers
After completing the
adjustment, press the TEST
TONE button again
(Re_ 1ore c _r rio! _rlt!
2
© @®
1,3
• After adjusting using the test tones, adjust the channel levels either according to the playback sources or to
suit your tastes, as described below
Select the speaker whose level you want to
adjust
The channel switches as shown below each
time the button is pressed
2 1
r_OEp 3_, 3.
2
Adiust the level of the selected speaker
f[vllr u/J9 (Rem?e contto! urtl
When the surround back speaker setting is set
to "Ispkr" for "Speaker Configuration", this is
set to "SB".
NOTES:
• The adjustment range for the different channels
is +12 dB to -12 dB
• When using the DIRECT mode, the sound from
the subwoofer can be cut by Iowedng the SW
(subwoofer) setting one step from -12 dB
(setting it to "OFF"}
• This function makes it posT ble to lower the volume of the front channels (FL, C and FR) or the rear channels
(SL, SR, SBL and SBR) together Use it for example to adjust the balance of the sound from the different
positions when playing multEchannel music sources
Select "FADER"
c_vo
(Man Jl_it] (Rer tote CXtlO b/it/
The channel switches in the order shown
below each time this button is pressed
oooo . .
ID°
2 1
2
Press the z button to reduce the volume of the
front channels, the ' button to reduce the
volume of the rear channels
_4 The fader function does not affect the SW
channel
(Man Jl_it] (Rer tote CXtlO b/it/
The channel whose channel level is adjusted
lowest can be faded to -12 dB using the fader
function
if the channel levels are adjusted separately after
adjusting the fader, the fader adjustment values
are cleared, so adjust the fader again
coo,to/JBiiii;T
_1T _1 T al T *lit *IITaT I T
= = i i i I i
This is only displayed w/en set[ing the fader control
[ T9}oIf: ::::
ID°
1 3,5 1,4,6
Select the Dolby Surround Pro Logic 1] mode
• The Dolby Pro Logc indicator lights
_ _,_ Ligh! Display
{B/lair1 u/it} {Rer tote cXitlO _/it/
Play a source with the nn_ mark
program
• For operating instructions, refer to the manuals of the
respective components
3
4,5,6
1
RHP
OOOO
(9 Q ®
q, @
© ® ®
27