Manual

I_t]]![.111
I_|_
If your AV component is not a Denon product or if it cannot be operated using the preset memory, t can be
controlled with the included remote control unit by storing its remote control signals in the remote control unit
Press the power ON/SOURCE button and the
OFF button simultaneously
• "SET UP" appears on the remote control
unit's display
1,5,8
3,4
2 Press the ENTER button
2,3,4
Use the and cursor buttons to dsplay
"LEARN" on the remote control unit's display,
then press the ENTER button
• r'SEL MODE" is displayed
4
5
Use the / and / cursor buttons to select the
mode for the button to be "learned", then press
the ENTER button
• "SELECT KEY" is displayed
Press the button to be 'qeamed" while
"SELECT KEY" is displayed "NOW LEARN"
appears
• "NOT VALID" is displayed if a button that
cannot be "learned" is pressed
• To cancel, press the power ON/SOURCE
button and the OFF button simultaneously
6
Poi_t the remote control units directly at each
other and press and hold in the button on the
other remote control unit which you want to
"learn"
"COMPLETE" appears on the remote co_trol
unit's display and learning is completed
• "SELECT KEY" s d splayed Other keys can
be "learned" by repeating steps 5 to 7
8 To cancel the learning mode, press the power
ON/SOURCE button and the OFF button
simultaneously again
Regstedng is not possible in the receiver
mode
The included remote control unit is equipped with a system call function allowing a series of remote control
signals to be transmitted by press4ng a single button
This function can be used for example to turn on the amplifier's power, select the input source, turn on the
monitor TV's power, turn on the source component's power and set the source to the play mode, all at the touch
of a button
(1) System call buttons
The buttons that ca_ be used for the system call
function are shown on the d agram at the right
System call signals can be stored at different
buttons accordng to the mode System can
s4gnals can be stored at a maximum of 6 buttons
other than the CALL I and CALL 2 buttons
29 successive operations can be set at each of
these buttons
(2) Storing system call signals
Press the power ON/SOURCE button and the
OFF button at the same time "SET UP"
appears on the remote control unit's display
2 Press the ENTER button
Use the and 1' cursor buttons to display "SYS
CALL" on the remote control unit, then press
the ENTER button
• Display "SYS MODE" on the remote control
unit's display
4
When "SYS MODE" is displayed, the remote
control unit's display switches as shown below
each time the " and cursor buttons are
pressed
Whe_ "SYS CALL 1" or "SYS CALL 2" is
selected, the signals are stored at the SYSTEM
CALL 1 and CALL 2 buttons (green), regardless
of the mode When the enter button s pressed,
the button registering mode (step 6) is set
Tu register at other buttons, select "SYS
MODE" then press the enter button
• After "SEL MODE" is displayed on the
remote control unit's displa% the mode last
set is displayed
®
_MP
)ooo
® @ @
® @ @
3,4,5
2,3, 5, 6,8 _+_,,
© ®
@ ®
© ©
19