Operating instructions

Select the play mode.
Example: Stereo
STEREO
%
(Remote control unit)
4
Adjust the volume.
SURROUND SELECT
MODE
(Main unit)
"_ To select the surreund mode while adjusting the surreund
parameters, channel volume er tone control, press the
surreund mode button then operate the selecter.
SURROUND
MODE
%
(Main unit)
Start playback en the selected cemponent.
• Fer eperating instructions, refer to the cempenent's
manual.
@ MASTERVOLU_4E
The volume level is
displayed on the (Remote control unit) (Main unit)
master volume bvel
display.
'_ The volume can be adjusted within the range ef -80 to 0 te 18 dB,
in steps of 0.5 dB. However, when the channel level is set as
described on page 32-34 er pages 68 and 69 if the volume for any
channel is set at +0.5 dB er greater, the volume cannet be adjusted
up to 18 dB. (in this case the maximum velume adjustment range
is "18 dB -- (Maximum value ef channel level)".)
Input mede when playing DTS sources
• Noise will be output if DTS-compatible CDs er LDs are played in the
"ANALOG" or "PCM" mode.
When playing DTS-compatible seurces, be sure to cennect the
source component te the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to "DTS".
Input mode display
• In the AUTO mode
I_0T6q
• In the DIGITAL PCM mode
[2N]
• In the DIGITAL DTS mode
• In the ANALOG mode
• In the EXT.IN mode
i/};',!_ii(iii _ i !iiii!_
Depending on the input signal.
iiiii,ii:!:il;!i!_!iii_!!_!!_iiii!(}ii:!}iiii!i{;i;i::i;i_iiiiiii_i:i:_ij@_ii
Input signal display
• DOLBY DIGITAL
f111DIGITAL
• PCM
'_ The _ indicator lights when digital signals are being input
properly. If the _ indicator does not light, check whether the
digital input cemponent setup (page 37) and connections are
correct and whether the compenent's power is turned on.
÷ AL24 precessing is activated when PCM signals are played while
the surreund mode is set to PURE DIRECT, DIRECT, STEREO.
NOTE:
• The _ indicator will light when playing CD-ROMs
containing data ether than audie signals, but ne sound will be
heard.
60