Operating instructions

(1) System call buttons

Up to 10 signals each can be stored at the "CALL1 " and "CALL2"

buttens.

The accessorious remete centrol unit is equipped with "system call" function allewing a series ef remete control signals to be transmitted by

pressing a single button.

This function can be used for example to turn on the amplifier's pewer, select the input seurce, turn en the monitor TV's pewer, turn en the seurce

component's power and set the seurce te the play mede, all at a signal butten.

....

DENON

RC-974

(2) Storing system call signals

OFF

ON/SOURCE

Press the power ON/SOURCE button and

the OFF button at the same time.

• The LEARNED/TX indicator flashes.

_ Press the CALL 1 button.

• The mode selecter buttons and

LEARNED/TX indicator flash.

Press the mode buttons of the equipment that is te be

registered to System Call.

CABLE

Press the buttons whese remete centrol signals you want te

store one by ene.

Repeat steps 3 and 4 te register the desired buttens.

_ Press the CALL1 or CALL2 button and

--1

NOTES:

• The remote centrol signals for the buttens pressed while storing the system call signals are transmitted when the buttons are pressed, so

cover the remete senser or take other measures se that the components de not operate while the signals are being stered.

• The mode butten and LEARNED/TX indicator flashing rapidly if you have already stored the maximum number of signals.