Operating instructions

4
Select the component (Y, PB/CB and PR/CR)video input terminal to be assigned to the input source.
Select the source
_ selection.
(Remote control unit} (Remote control unit}
J_
Select the component
video input terminal.
Select "NONE" for sources fer which the cemponent (Y, PB/C8 and PR/CR)video input is not te be used.
"_ When the default, "Yes", is selected, the settings are reset to the factery defaults.
(Ren_lote control unit/
Enter the setting.
The Input Setup Menu reappears.
1
2
(Remote control unit}
Select "Video Input Mede" at the Input Setup Menu.
I
3
I
i ,::i e O Z[ i'1 o ,:J ::_:
*3. Input Setup
1. Digital in Assign
2. Ext. In Subw00fer Level
3. Component In Assign
_4. Video Input Mode
5. Auto Tuner Presets
Exit
(Remote control unit}
Display the Video Input Mode screen.
I
3
:_:iii ,:i(_,o ]1n i*io ,::i(_ I
I
[> [> ',',41i:iu i: o _.
3-4. Video input Mode
_: AUTO
E_: AUTO
J_: AUTO
_: AUTO
J_: AUTO
F_: AUTO
Default E_4
(]) Select the input seurce fer which you want to set the
Vide<) Input Mede.
2_, Select the mode as below.
[_-AUTO_COMPONENT_ Svideo_ Video _ I
The details in each mode are as follows.
(Remote control unit}
G
(Remote control unit)
AUTO:
Component:
S-Video:
Video:
When there are multiple input signals, the input signals are detected and the input signal to be eutput frem the vide<)
monitor output terminal is selected automatically in the following order: component vide(), S-Video, compesite vide<).
The signal connected to the component video terminal is always played.
Video conversion is net conducted, so no image is output from the monitor eutput terminal when there is ne input signal
to the component terminal.
The signal connected te the S-Video terminal is always played.
The S-Video input signal is converted and eutput frem the composite and cempenent monitor output terminal.
The signal connected te the compesite video terminal is always played.
The composite video input signal is up-cenverted and eutput from the S-Videe and component monitor eutput terminals.
39