Operating instructions

• Use this setting when using a microphene other than the included one for measurements when performing the auto setup procedure.
• The micrephone included with the AVR-2805 is a measurement microphone designed specifically for use during the auto setup precedure.
Select "Mic" and connect the included microphone to the "SETUP MIC" mini-jack. When conducting the auto setup procedure using a separate
high performance cendenser microphone for measurements, select "V.AUX L" and connect the microphone te the "V.AUX Lch" pin jack.
•_ Please ask the DENON Authorized Service Center about the usable microphone other than the option setup.
1
@
(Remote control unit)
Select "Mic Input Select" at the Aute Setup / Roem EQ Menu.
" I
q: H U "t O !:, e "t e<'O O m e: _!
H i c 1[ i_ S e ] ec ¢
1, Auto Setup/Room EQ
1. Auto Setup
2. Manual EQ Setup
3, Room EQ Setup
4. Direct Mode Setup
_5. Mic Input Select
6. EQ Parameter Check
Exit
2
(Remote control unit)
Display the Mic Input Select screen.
Select the Mic input jack or V.AUX L jack.
'9
H ic I,
1-5. Mic Input Select
I_n_ _ :, [_ L
4
%
(Remote control unit/
Enter the setting.
The Aute Setup / Room EQ Menu reappears.
• The frequency characteristic ef each speaker is rectified and the tone of the speaker is unified.
The EQ parameters that were set in Auto Setup can be checked.
This item is automatically displayed, after the measurement result of the "Aute Setup / Reem EQ" is decided.
1
@
(Remote control unit/
Select "EQ Parameter Check" at the Auto Setup / Reom EQ
Menu.
_o
:_:Fi u J; o S e -i: R o o _,_E Q
F' B r B m e "i: e r {]: ::_:C i::
1. Auto Setup/Room EQ
1, Auto Setup
2, Manual EQ Setup
3. Room EQ Setup
4. Direct Mode Setup
5, Mic Input Select
_6. EQ Parameter Check
Exit
2
%
(Remote control unit/
Display the EQ Parameter Check screen.
I
15
I
t-6, EQ Parameter Check
_l:Normat
2:Front
3:Flat
Exit
28