Operation Manual

ENGLISH
Remote Control Unit Operations
Depending on the model and year of manufacture of your equipment,
some buttons may not operate.
[MODE
SELECTOR 1]
[MODE
SELECTOR 2]
• The signals for the pressed buttons are emitted while setting the
preset memory. To avoid accidental operation, cover the remote
control unit’s transmitting window while setting the preset memory.
• Depending on the model and year of manufacture, this function
cannot be used for some models, even if they are of makes listed in
the list of preset codes.
• Some manufacturers use more than one type of remote control code.
Refer to the included list of preset codes to change the number and
verify correct operation.
• The preset memory can be set for one component only among the
following: TAPE/CD-R/MD, DVD/VDP and SAT/CABLE.
1
Set [MODE SELECTOR 1] to “AUDIO” or “VIDEO”.
b Set to the AUDIO side for the CD or TAPE/CD-R/MD position,
and to the VIDEO side for the DVD/VDP, SAT/CABLE, VCR or TV
position.
2
Set [MODE SELECTOR 2] to the component you want
to operate.
3
Operate the component.
b For details, refer to the component’s operating instructions.
b Some models cannot be operated with this remote control unit.
Operating DENON Audio
Components
1
Set [MODE SELECTOR 1] to “AUDIO”.
2
Set [MODE SELECTOR 2] to the position for the
component to be operated (CD, iPod/NETWORK or
TAPE/CD-R/MD).
3
Operate the audio component.
b For details, refer to the component’s operating instructions.
b While this remote control is compatible with a wide range of
infrared controlled components, it may be the case that some
component models cannot be operated with this remote control.
1
Set [MODE SELECTOR 1] to “AUDIO” or “VIDEO”.
b Set to the AUDIO side for the CD or TAPE/CD-R/MD position,
and to the VIDEO side for the DVD/VDP, SAT/CABLE, VCR or TV
position.
2
Set [MODE SELECTOR 2] to the component to be
registered.
3
Press [DVD/VDP POWER] and [TV POWER] at the
same time.
The indicator starts flashing.
4
Referring to the included list of preset codes, press
[NUMBER] to input the preset code (a 3-digit number)
for the manufacturer of the component whose signals
you want to store in the memory.
5
To store the codes of another component in the
memory, repeat steps 1 to 4.
[DVD/VDP
POWER]
[NUMBER]
[TV POWER]
[Front]
[Rear]
Presetting
• DENON and other makes of components can be operated by
setting the preset memory.
• Operation is not possible for some models.
Operating Preset Components

Getting Started Connections Setup Playback Remote Control Amp Assign Information Troubleshooting