Operation Manual

ENGLISH
Master Volume
Master volume display during adjustment.
[Selectable items]
ON
: Turn display on.
OFF
: Turn display off.
Tuner Information
This sets the time the on-screen display is displayed when an operation
is performed.
[Selectable items]
Always
: Show display continuously.
30sec
: Show display for 30 seconds after operation.
10sec
: Show display for 10 seconds after operation.
OFF
: Turn display off.
Display Mode
Select the on-screen display's display mode.
[Selectable items]
Mode1
: If there is no video signal, flickering of the on-screen
display is not prevented.
Mode2
: Prevents flickering of the on-screen display when there is
no video signal.
Use this mode if the on-screen display does not appear
in the Mode 1, as may happen according to the TV being
used.
iPod Information
This sets the time the on-screen display is displayed when an operation
is performed.
[Selectable items]
Always
: Show display continuously.
30sec
: Show display for 30 seconds after operation.
10sec
: Show display for 10 seconds after operation.
OFF
: Turn display off.
g
Quick Select Name
Change the Quick Select name.
Up to 15 characters can be input.
[Input characters]
A ~ Z a ~ z 0 ~ 9 ! # % & ’ ( ) * + , - . / : ; = ” ? @ [ \ ] (space)
h
Remote ID Setup
Set remote control ID.
[Selectable items]
1 2 3 4
j
Display
Adjust display brightness of the receiver.
Operating from the remote control unit
Press the DIMMER button.
Bright Dim
DarkOFF
[Selectable items]
Bright
: Normal display brightness.
Dim
: Reduced display brightness.
Dark
: Very low display brightness.
OFF
: Display is off unless controls are operated.
NOTE
When using the AVR-1908 with only the included remote control unit
(RC-1078), there is no need to make settings.
k
Setup Lock
Protect settings from inadvertent change.
• When “Setup Lock” is set to “ON”, the settings listed below can
no longer be changed. Also, “SETUP LOCKED!” is displayed if you
attempt to operate related buttons.
⋅ Menu operations
⋅ RESTORER
⋅ Night Mode
⋅ Parameter
⋅ Room EQ
⋅ Channel Level
⋅ Audio Delay
• To cancel the setting, press the MENU button to re-display the “Setup
Lock” screen, then change the setting to “OFF”.
[Selectable items]
ON
: Turn protection on.
OFF
: Turn protection off.

Getting Started Connections Setup Playback Remote Control Amp Assign Information Troubleshooting