Operation Manual
Getting Started Connections Setup Remote Control Amp Assign Information Troubleshooting
ENGLISH
• The title name, artist name and album name can be checked by
pressing [STATUS] during playback.
• On the AVR-1708, folder and file names can be displayed as titles. Any
characters that cannot be displayed are replaced with “ . (period)”.
Stopping playback temporarily
During playback, press [ENTER] or [1].
Press again to resume playback.
Fast-forwarding or fast-reversing
During playback, either press and hold [u] (to fast-reverse) or [i] (to
fast-forward), or press [6] or [7].
To cue to the beginning of a track
During playback, either press [u] (to cue to the previous track) or [i]
(to cue to the next track), or press [8] or [9].
To stop
During playback, either press and hold [ENTER] or press [2].
Playing repeatedly
Press [CHANNEL –].
[Selectable items]
All
One
OFF
Shuffling playback
Press [CHANNEL +].
[Selectable items]
Albums
Songs
OFF
To switch between the Browse and Remote modes
Either press and hold [MODE].
Listening to Music in the Browse mode
1
Press [MODE] for 2 seconds or more, to change from
Remote Mode to Browse Mode.
(iPod screen)
2
Use [ui] to select the menu, then press [ENTER] or
[p] to select the music le to be played.
3
Press [ENTER] or [p].
Playback starts.
NOTE
• Depending on the type of iPod and the software version, some
functions may not operate.
• DENON will accept no responsibility whatsoever for any loss of iPod
data.
OK to disconnect.
1
Make the necessary preparations.
q Set the iPod in the DENON Control Dock for iPod.
(vSee the Control Dock for iPod’s operating instructions.)
w Assign the Control Dock for iPod’s input.
“System Setup” – ”Input Setup” – ”iPod Assign”
(vpage 24)
2
Either turn <SOURCE SELECT> or press [iPod] to
select the input source assigned in step 1-w above.
R e m o t e i P o d
b If the displays above are not displayed, the iPod may not be
properly connected. Try connecting again.
3
Set [MODE SELECTOR 1] to “AUDIO” and [MODE
SELECTOR 2] to “iPod/NETWORK”.
(vpage 42 “Remote Control Unit Operations”)
Basic Operation
• With the default settings, the iPod can be used connected to the VCR
(iPod) connector.
• Use the RESTORER mode to expand the low and high frequency
components of compressed audio files and achieve a richer sound.
The default setting is “Mode3” (vpage 32).
• Press <ON/STANDBY> and set the AVR-1708’s power to the standby
mode before disconnecting the iPod. Also switch the input source to
one to which “iPod Assign” is not assigned before disconnecting the
iPod.
iPod
®
Playback
The music on an iPod can be played by using the Control Dock for
iPod (ASD-1R, sold separately).
The iPod can be controlled using the buttons on the remote control
unit.
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
b The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.
Playback