Operation Manual

0
Getting Started Connections Playback Remote Control Amp Assign Information Troubleshooting
ENGLISH
PANORAMA
Assign front L/R signal also to surround channels, for wider sound.
If the surround effect seems weak, set “PANORAMA” to “ON”.
[Selectable items]
ON
OFF
DIMENSION
Shift sound image center to front or rear, to adjust playback balance.
[Variable range]
0
~
3
~
6
DELAY TIME
Adjust delay time to control sound stage size.
[Variable range]
0 ms
~
30 ms
~
300 ms
CENTER WIDTH
Assign center channel signal to front left and right channels for wider
sound.
[Variable range]
0
~
3
~
7
EFFECT LEVEL
Adjust the strength of the surround effect.
[Variable range]
1
~
10
~
15
Set to a lower level if the positioning and sense of phase of the
surround signals seems unnatural.
CENTER IMAGE
Assign center channel signal to front left and right channels for wider
sound.
[Variable range]
0.0
~
0.3
~
1.0
ROOM SIZE
Determine size of acoustic environment.
[Selectable items]
small
: Simulate acoustics of a small room.
med. s
medium
med. l
large
: Simulate acoustics of a large room.
NOTE
“ROOM SIZE” does not indicate the size of the room in which sources
are played.
SB CH OUT (for Multi-channel sources)
Select playback mode for surround back channels.
[Selectable items]
OFF
: No signal is played from the surround back
channels.
NON MTRX
: The same signals as those of the surround
channels are output from the surround back
channels.
MTRX ON
: The surround channel signals undergo digital
matrix processing and are output from the
surround back channels.
PL II x CINEMA
z1
: Decoded in Dolby Pro Logic IIx Cinema mode,
surround back signal played.
PL II x MUSIC
z2
: Decoded in Dolby Pro Logic IIx Music mode,
surround back signal played.
ES MTRX
z3
: DTS signal played with digital matrix processing.
ES DSCRT
z4
: Signal included in DTS-ES Discrete 6.1-channel
sources played.
z1: This can be selected when “Surround Back Speaker” is set to
“2spkrs” at “System Setup” – “Speaker Setup” setting (vpage
22).
z2: This can be selected when “Surround Back Speaker” is set to
“2spkrs” or “1spkr” at “System Setup” – “Speaker Setup”
setting.
z3: This can be selected when playing DTS sources.
z4: This can be selected when playing DTS sources including a
discrete 6.1-channel signal identification signal.
Setup