PORTUGUÊS ESPAÑOL FRANÇAIS ENGLISH AVR-1513 AV SURROUND RECEIVER Getting Started Mise en route / Antes de empezar / Iniciação 1.AVR1513E3_ENG_IM_GS_00A_0214校了後修正.
ENGLISH FRANÇAIS ESPAÑOL PORTUGUÊS ESPAÑOL NEDERLANDS SVENSKA Read before use Thank you for purchasing this DENON product. This manual explains the removal of the product from its packaging box and how to easily enjoy the home theatre system.
SVENSKA NEDERLANDS ESPAÑOL PORTUGUÊS ESPAÑOL FRANÇAIS ENGLISH Connecting the speakers Connect This unit can perform 2.0/2.1 to 5.1-channel surround playback. Here, we explain the installation and connection procedure when using 5.1-channel speakers. For the installation procedure when using other than 5.1-channel, see vm page 22 “Speaker installation/connection (Advanced connection)”. n Do not plug the power plug of the main unit into the wall socket until these preparations are complete.
ENGLISH FRANÇAIS ESPAÑOL PORTUGUÊS ESPAÑOL NEDERLANDS SVENSKA Preparation Connect Carefully check the left (L) and right (R) channels and + (red) and – (black) polarities on the speakers being connected to the this unit, and be sure to interconnect the channels and polarities correctly. Connecting the speaker cables Peel off about 0.03 ft/10 mm of sheathing from the tip of the speaker cable, then either twist the core wire tightly or terminate it.
SVENSKA NEDERLANDS ESPAÑOL PORTUGUÊS ESPAÑOL FRANÇAIS ENGLISH Before setting up the speakers Connect this unit to the television using an HDMI cable (sold separately) 3 Connect 1 Insert the main unit power plug into the wall socket When a device supporting Deep Color signal transfer is connected, use a cable compatible “High Speed HDMI cable” or “High Speed HDMI cable with Ethernet”.
ENGLISH FRANÇAIS DEUTSCH FRANÇAIS ESPAÑOL PORTUGUÊS ITALIANO ESPAÑOL NEDERLANDS SVENSKA Set up speakers For optimum surround playback, adjustment of the distance of speakers and sound level of each channel, using the test tone, are required, depending on the environment for speakers to be used. The settings for the following 5 items should be made: Speaker Config. Select speaker configuration and size (bass reproduction capability). Speaker Config. 1 Press SETUP.
SVENSKA Speaker Config. (Cont.) Set the presence of a subwoofer. • Yes : Use a subwoofer. • No : Select when a subwoofer is not connected. When “Front” is set to “Small”, “Subwoofer” is automatically set to “Yes”. Bass Setting 1 FRANÇAIS ESPAÑOL Default settings are underlined. Use ui to select “Bass Setting”, and then press ENTER. FRANÇAIS DEUTSCH ENGLISH Default settings are underlined.
ENGLISH FRANÇAIS DEUTSCH FRANÇAIS ESPAÑOL Distance (Cont.) PORTUGUÊS ITALIANO ESPAÑOL NEDERLANDS SVENSKA Channel Level Default settings are underlined. ui to select a speaker, and use Use ui to select “Channel Level”, ui to select a speaker, and use 3 Use 1 and 3 Use 4 Press ENTER to enter the setting. o p to select distance. then press ENTER. o p to adjust the sound volume of Front L / Front R / Center / Subwoofer / Surround L / Surround R Select the speaker. • 0.0ft – 60.0ft : Set the distance.
SVENSKA Front Center Surround 80Hz 80Hz 80Hz ENGLISH to select a speaker, and use to select the frequency. • “Crossover Freq.” can be set when the “Bass Setting” – “SW Mode” (vpage 6) setting is “LFE+Main”, or when you have a speaker that is set to “Small”. • Always set the crossover frequency to “80Hz”. When using small speakers, however, we recommend setting the crossover frequency to a higher frequency. • For speakers set to “Small”, sound below the crossover frequency is cut from the sound output.
www.denon.com V00 5.AVR1513E3_BackPage_IM_GS_0214校了後修正.indd 3 D&M Holdings Inc.
