Specifications

Ease-of-Use
Control Link allowing POA-A1HD settings to be made via the AVP-A1HDA
remote control unit (includes Control Link Cable: 3 m)
With the POA-A1HD, it is possible to switch among XLR, RCA, and OFF for
the input signals and among Bi-Amp, NORMAL, and BRIDGE for the types of
output, for each channel. The POA-A1HD is also equipped with Control Link to
enable communication with the AVP-A1HDA. When connected with a Control
Link Cable, these settings can be made using the remote control unit that comes
with the AVP-A1HDA. (When the POA-A1HD is used on its own, switches on the
rear panel are used to change the settings.)
VU meters available of any channel
Other Features
RCA and XLR input for each channel
Bi-Amp / Bridge mode select
Bridged or bi-amp connections are possible by setting a switch on the rear
panel that will enable the connection of a 2-channel unit to a single-channel
input. Settings are made individually for each channel so that the front and centre
channels can be bridged and the surround and back surround channels can be
used singly. During linked control from the AVP-A1HDA, the connection method
can be selected from the AVP-A1HDA’s remote controller.
Gold plated wide pitch speaker terminal
Trigger input
RS-232C
*Design and specifications are subject to change without notice.
*THX is a trademark of THX Ltd. THX may be registered in some jurisdiction. All rights reserved.
22 23
Input / Output terminals
IN XLR 10
RCA 10
OUT Speaker A L/R out 10
Speaker B L/R out 10
Others Trigger +12 V, 250 mA 1
RS-232C 1
Control link IN 1 / OUT 1
Specifications
Power Amplifier Section
Rated output 150 W (8 ohms)
300 W (4 ohms)
300 W (8 ohms) Bridge Connection
500 W (4 ohms) Bridge Connection
General
Power supply AC 230 V, 50 Hz
Power consumption 1,300 W
(Standby: 0.3 W )
Dimensions (W x H x D) 434 x 281 x 530 mm
Weight 60 kg