Stereo Receiver User Manual

n
Audio section
• Power amplifier
Rated output:
Front:
150 W + 150 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
170 W + 170 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Center:
150 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
170 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Surround (A + B):
150 W + 150 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
170 W + 170 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Surround back:
150 W + 150 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
170 W + 170 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Dynamic power:
200 W x 2ch (8 Ω/ohms)
340 W x 2ch (4 Ω/ohms)
Output connectors:
Front, Center, Surround back 6 ~ 16 Ω/ohms
Surround: A or B
6 ~ 16 Ω/ohms
A + B
8 ~ 16 Ω/ohms
• Analog
Input sensitivity / Input impedance:
200 mV / 47 kΩ/kohms
Frequency response:
10 Hz ~ 100 kHz +1, –3 dB (DIRECT mode)
S/N:
102 dB (IHF–A weighted, DIRECT mode)
Distortion:
0.005 % (20 Hz ~ 20 kHz, DIRECT mode)
Rated output:
1.2 V
• Digital
D/A output:
Rated output — 2 V (at 0 dB playback)
Total harmonic distortion — 0.005 % (1 kHz, at 0 dB)
Dynamic range — 110 dB
Digital input:
Format — Digital audio interface
• Phono equalizer (PHONO input — REC OUT)
Input sensitivity:
2.5 mV
RIAA deviation:
±1 dB (20 Hz to 20 kHz)
S/N:
74 dB (A weighting, with 5 mV input)
Rated output:
150 mV
Distortion factor:
0.03 % (1 kHz, 3 V)
Specifications
GXM Satellite RadioH
Symptom Cause Countermeasure Page
“LOADING” is
displayed in the
XM mode.
• The XM Mini-Tuner is acquiring
audio or program information
from the XM satellite signal. This
message can also occur in weak
XM signal conditions. (Note that
the AVR-5308CI may not respond
to some buttons for XM while
this message is displayed.)
• This message should disappear
in a few seconds in good signal
conditions. If you see this
message often, reposition the
XM antenna for better signal
reception.
60
“NO SIGNAL” is
displayed in the
XM mode.
• The XM Mini-Tuner is not
receiving the XM satellite signal.
Something may be blocking
the XM antenna’s view of the
satellites or the antenna is not
properly aimed.
• Check for antenna obstructions
and reposition the XM antenna
to get better signal reception.
See instructions supplied with
the XM Mini-Tuner and Dock for
antenna installation information.
60
“OFF AIR” is
displayed in the
XM mode.
• You selected an XM channel is
not currently broadcasting.
• Check back later; in the mean
time, select another channel.
60, 61
“UP DATING” is
displayed in the
XM mode.
• You selected an XM channel that
is blocked or cannot be receive
with your XM subscription
package.
• Consult the latest channel guide
at www.xmradio.com for the
current list of channels. For
information on receiving this
channel, visit www.xmradio.com
or contact XM Satellite Radio at
1-800-967-2346.
–
“XM - - - ” is
displayed in the
XM mode.
• The selected channel is not
available. The channel may have
been reassigned to a different
channel number. This message
may occur initially with a new
radio or a radio that has not
received XM’s signal for an
extended period.
• Consult the latest channel guide
at www.xmradio.com for the
current list of channels. For cases
of a new radio or a radio that has
not received XM’s signal for an
extended period, allow the radio
to receive the XM satellite signal
for at least 5 minutes and then
try to select the channel again.
–
0
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
AVR5308CIEU_100_初校作成中.indd 110 2008/05/26 9:44:08