Owner's Manual
Table Of Contents
- Sound Bar 550
- Owner’s Manual
- Contents
- What you can do with this unit
- Accessories
- Part names and functions
- Positioning
- Troubleshooting
- Power does not turn on / Power is turned off
- Operations cannot be performed through the remote control unit
- Trouble teaching this unit remote control commands
- No sound comes out
- Music cuts out or delays sometimes
- The HDMI Control function does not work
- Audio can be heard coming from the TV’s speakers
- I hear a delay when using the external input with my TV
- Bluetooth playback does not work
- Cannot connect the sound bar to the network
- Connecting to a network using an iOS device
- Connecting to a WPS network
- This unit takes long time to turn on
- Cannot operate the unit with Alexa
- Alexa does not respond even if called
- Resetting factory settings
- Resetting the firmware to the default state
- Quick Start Guide
- Owner’s Manual
- Wireless Speaker Home 150
- Owner’s Manual
- Contents
- Introduction
- Before your begin
- Setup
- Use
- Using your speaker
- Selecting a room/speaker
- Quick Select function
- Listening to radio
- Playing music stored on your mobile device
- Playing music from your networked PC or NAS
- Playing music from the AUX input
- Playing music from a USB memory device
- Playing music from Bluetooth device
- HEOS account
- Playing from streaming music services
- Managing inputs
- Managing your phone
- Listening to the same music in multiple rooms
- Stereo pairing
- Using the now playing queue
- Rearranging the now playing queue
- Deleting songs from the play queue
- Deleting all songs from the play queue
- Saving playlists
- Performing repeat and shuffle playback
- Using the favorite
- AirPlay function
- Making speaker adjustments
- Updating your system
- Advanced features
- Power management
- Using your speaker
- Troubleshooting
- Cannot connect the speaker to the network
- Cannot pair a Bluetooth mobile device with the speaker
- Cannot hear Bluetooth music
- Music cuts out or delays sometimes
- hear a delay when using the AUX input with my TV
- Connecting to a network using an iOS device
- I hear distortion when using the AUX input
- Connecting to a WPS network
- Resetting your speaker
- Buttons do not operate correctly
- Status LED table
- Appendix
- Quick Start Guide
- Owner’s Manual
- Wireless Home Subwoofer
I hear distortion when using the AUX input
Solution Refer to Page
0
The analog output signals from some sources can be fairly strong. If the input level of the source device is turned up high, it
could overload the inputs of the speaker. This is unlikely to cause damage, but can cause distorted sound. Initially, set the
volume of the source to a medium – low level, then turn it up as needed. If you hear distortion, turn down the device’s volume
control.
－
Connecting to a WPS network
Solution Refer to Page
If your wireless router support WPS (Wi-Fi Protected Setup™) your speaker can optionally connect to your network using the
“Push Button” method by following these steps:
Wi-Fi Protected Setup™ is trademarks of Wi-Fi Alliance.
1. Press the WPS button on your router.
2. Within 2 minutes, press and hold the CONNECT button on the rear panel of the speaker for 3 seconds.
3. The LED on the front of the speaker will flash green for several seconds as it connects to your WPS router.
4. When the connection is complete, the LED on the front of the speaker will turn solid blue.
6
Contents Setup Use Troubleshooting Status LED Appendix
53