Specifications

Page 15
Page 16
4010 320th St.
P.O. BOX 189, BOYDEN, IA. 51234
PH: [phone] FAX: [phone]
TOLL FREE: 1-800-54DEMCO (1-800-543-3626)
www.demco-products.com
Rue Ring Installation
To install Rue Ring, place straight wire of Rue Ring through hole in pin as
shown in illustrations ( Figure B 1- 2)
Next, using a pliers, twist end of Rue Ring so the straight wire crosses over top
of the bent wire. ( Figure B 3)
Figure B illustration 4 shows removal of Rue Ring. Uncross wires, then while
lifting the bent wire, pull on loop end of the Rue Ring to remove from pin.
Locked
Pin installed.
Bent leg behind
straight leg.
Lock position
Bent leg must
be on top of
straight leg then
push up & back.
TO REMOVE
Figure A
Figure B
* Required for safe operation.
Install into hole.