Specifications

Page 5
The weight rating of the coupler is dependent on the
correct bolts being used. You must use the bolts
provided with the product. If you are missing bolts,
refer to your Operator’s Manual and obtain replace-
ments from Demco, or use the exact size, grade, and
number of bolts as specified. Using the wrong size,
grade, or number of bolts will reduce the weight rat-
ing of the coupler and could cause separation of your
towing equipment from the towing vehicle. If you
have questions about the correct bolts for your ap-
plication call Demco at any of the following telephone
numbers:
[phone]
[phone]
1-800-543-3626
FAX: [phone]
WARNING: TO AVOID PERSONAL INJURY OR PROPERTY
DAMAGE, OBSERVE THE FOLLOWING INSTRUCTIONS:
!
WELDING
Tack Actuator down on the
four corners then weld in a
criss cross pattern using 2”
to 2-1/2” welds with 2”
spaces between welds
(when welding down to a
flat area of the tongue)
Do not weld in the
circled area
Do not weld in the
circled area
Keep braces and welds
back to allow access to
shock pin holes
Keep braces
and welds
back to allow
access to
shock pin hole
Use gussets to sup-
port the back of the
actuator if welding in
position shown
Keep gussets
on rear of ac-
tuator to lower
half to avoid
circled area
Weld as shown
NOTE: disassembly of the actuator before welding is recommended