Specifications

Page 7

Step 3. Remove pins that attach tow bar to towed vehicle.

Aluminator

will remain in position. Slide the extendable legs

back into tube. Position electrical cable on storage rod and

insert pin to prevent cable from sliding off.

Step 4. Now fold both legs together and push them upward.

Step 5. Rotate them counter-clockwise into the storage posi-

tion. The unit is self supportive in this position. Insert the small

hairpin into the lockpin inside the front yoke. Cover your

Aluminator

and you are ready to drive your vehicle.

NOTE: Picture shown in 45 degree position. Aluminator

will also store in 90 degree position.

NOTE: If you need to store your Aluminator

on the

opposite side you must rotate the rear yoke 180 and

rotate the legs clockwise into the storage position.

Step 7. Once you are secured to the tow bar, release towed

vehicle parking brake, and slowly back up the towed vehicle

straight back until one leg latches. Determine which leg

latched by having an assistant tell you. If you are by yourself

put towed vehicle in neutral or park, and apply parking brake.

Get out and check to see which leg latched, you can tell by

which leg has green stripe shown by lock collar. To latch the

second leg turn the top of towed vehicles steering wheel into

the direction of the leg that first latched, and slowly back up

again. This will latch the second leg. Once both legs are

latched straighten wheels on towed vehicle, shut vehicle off.

If manual transmission, shift to neutral, unlock steering wheel,

and make sure parking brake is released. Note: For four

wheel drive units, shift transfer case into neutral also.

Reminder: Consult vehicles manufacturer for towing suitabil-

ity, for manual or automatic transmission vehicles.

UNHOOKING THE TOWED VEHICLE

Step 1.

Begin unhooking your unit by first applying both vehicle

parking brakes and unhook your lighting and safety cables.

Failure to have parking brakes applied could allow towed

vehicle to roll forward, this could result in limited space

between towing vehicle and towed vehicle.

Step 2. Use the Lock Collar Release Tool to relieve any

pressure in the connecting legs between the two vehicles.

Green Stripe