Specifications

Page 9
29 04594 - EPDM Black Tubing
30 05561 1 Solenoid Valve Bypass
31 10373 1 Brass Fitting Str. .2 HB x 10-32 NF
32 10374 2 Crimp Clamp
33 10375 1 Straight Nipple 1/8” MPT x 1/8” MPT
34 10376 1 Brass Elbow 1/8” MPT x .2 HB
35 11675-95 1 Solenoid Cover
REF. PART
NO. NO. QTY. DESCRIPTION
KIT #5753 PARTS LIST FIELD INSTALL
35 11675-95 1 Solenoid Cover
36 11993 1 Inline Solenoid Valve Non-Bypass
37 07283 1 10mm Flatwasher
REF. PART
NO. NO. QTY. DESCRIPTION
KIT #5838 PARTS LIST FIELD INSTALL
Optional by-pass solenoid kits
5754 (FACTORY INSTALL)-(DRUM)
5755 (FACTORY INSTALL)-(DISC)
Drill the hole using a 5/32” bit. Hole loca-
tion is .900” right of top left corner and .900”
down from top of master cylinder. Tap hole
with 10-32 NF tap.
29
30
32
33
34
32
35
31
36
37
Free Backing Solenoid Kit Options
The weight rating of the coupler is dependent on the correct bolts being used. You must use the
exact size, grade and number of bolts specified in the manual. Mounting hardware can be obtained
from Demco, trailer parts distributors or fastener supplier.
WARNING: TO AVOID PERSONAL INJURY OR PROPERTY
DAMAGE, OBSERVE THE FOLLOWING INSTRUCTIONS:
WELDING
Tack Actuator down on the
four corners then weld in
a criss cross pattern us-
ing 2” to 2-1/2” welds with
2” spaces between welds
(when welding down to a
flat area of the tongue)
Do not weld in the
circled area
Do not weld in the
circled area
Keep braces and welds
back to allow access to
shock pin holes
Keep braces
and welds back
to allow access
to shock pin
hole
Use gussets to support the
back of the actuator if welding
in position shown
Keep gussets on
rear of actuator
to lower half to
avoid circled
area
Weld as shown
NOTE: disassembly of the actuator before welding is recommended
1
2
3
4
5
6
7
8