User's Manual

63
211 338 44.indd / 081019
Function with parameter setting = 0
43680744.eps 43680844.eps
Function with parameter setting = 1
Parameter 508 is used to set whether both axes of the left joystick can be
controlled at the same time (e.g. diagonal travel) or only separately (cross template
function).
This function represents the electronic simulation of a mechanical gate. The axis
which is first selected by movement of the joystick is enabled for operation, while
the second axis is disabled.
The default standard setting is 0, i.e. the electronic gate is de-activated (default).
The current setting is shown on the screen. Use the following buttons to navigate:
Button Function
→ Change to display of parameter 501
← Change to display of parameter 507
↑ Exit parameter programming menu
F1 Change to entry and selection mode
When the system has been switched to entry and selection mode, you can select
between a non-activate or active electronic gate:
Selection Meaning
Parameter 0 The electronic gate is de-activated (default). Both axes can be
controlled at the same time (diagonal travel)
Parameter 1 The electronic gate is activated: only the axis which is actuated first
by movement of the joystick is enabled. The second axis is disabled
during this time.
P1.4.1 Display mode
P1.4.2 Entry and selection mode
Use the following buttons to select and navigate:
Button Function
→ Display the next possible value
← Display the previous possible value
↑ Exit parameter programming menu
F2 Accept the displayed setting
The joystick can be moved in all directions.
The joystick can only be moved in one direction.
P1.4 Activating the
electronic gate for
the left joystick,
parameter code 508