User's Manual

61
211 338 44.indd / 081019
509 Transmitter power output
Parameter can be changed
Sets the power output of the DRC-MJ D3 hand-held transmitter
Can be set at three levels: 1 = low, 2 = medium, 3 = maximum
Default: 3 = maximum
Note: Lower transmission power output reduces the range, but also any possible
interference by the transmitter on other 2,4 GHz radio systems. Only change this
parameter in agreement with the manufacturer.
510 Transmission frequency
Parameter can be changed
Sets how often the equipment transmits at a certain transmission frequency (media
assignment).
Can be set at two levels: 1 = 20 Hz, 2 = 10 Hz
Default: 2
Note: Only change this parameter in agreement with the manufacturer.
511 Receiver response frequency
Parameter can be changed
Can be set at ten levels
Default: 5
Note: Only change this parameter in agreement with the manufacturer.
512 Listen before talk (LBT)
Parameter can be changed
Adjust the adaptive behaviour of radio transmission
Can be set at three levels
Default: 0
Note: Only change this parameter in agreement with the manufacturer.
513 Vibration alarm on
Parameter can be changed
Activates or de-activates the vibration alarm integrated in the hand-held transmitter
Can be set at 2 levels: 0 = off, 1 = on
Default: 1
Note:
The vibration alarm drains the rechargeable battery capacity of DRC-MJ D3 hand-
held transmitters: de-activating the vibration alarm can, therefore, extend the
operating period for a battery charge.
514 White background illumination
Parameter can be changed
Controls the white background illumination
Can be set at 3 levels:
0 = off, 1 = on for 3 seconds when a button is pressed, 2 = continuously on
Default: 1
Note:
The background illumination drains the rechargeable battery capacity of
DRC-MJ D3 hand-held transmitters: de-activating the background illumination
can, therefore, extend the operating period for a battery charge. Leaving the
background illumination continuously switched on may drastically increase power
consumption.