User's Manual

59
211 338 44.indd / 081019
The “Hand-held transmitter parameter programming” menu can be used by
specially trained personnel for displaying and also partly changing the following
settings of the DRC-MJ D3 hand-held transmitter:
Parameter no. Description Edit
501
S/N No
502
SW version No
503
HW version No
504
-
505
Timeout in STOP mode Yes
506
Timeout in RUN mode Ye s
507
Invert lifting/lowering Yes
508
Electronic gate Yes
509
Transmitter power output Yes
510
Transmitter duty cycle Yes
511
Information feedback rate Yes
512
Listen before talk (LBT) Yes
513
Vibration alarm Yes
514
White background illumination Yes
515
Activate WCB function Yes
516
Adjust display contrast Yes
000
Log off receiver Yes
The menu can be activated in Run mode or STOP mode.
– Hold the STOP button down.
– Push the LIFT joystick.
– Push the LEFT joystick twice.
– Push the LIFT joystick and hold it down for approx. 5 seconds.
– Release the LIFT joystick.
– Release the STOP button.
Only the parameter number and the current parameter value are displayed when
the menu is first activated. The screen starts with parameter 301, i.e. the serial no.
of the DRC-MJ D3 hand-held transmitter:
P1 Menu for programming the DRC-MJ D3 hand-held transmitter
parameters
P1.1 Activating the menu
43605344.eps
00000314
K564
301:
Parameter no.
Parameter value
Lower
F2
Long travel to right
Right
Stop
Lift
F1
Left
Long travel to left
Horn
43666944.eps