User's Manual

211 338 44.indd / 081019

– Press the HORN pushbutton to confirm that the new radio transmitter has

taken over control. The radio transmitter is actively connected to the DRC radio

receiver.

The transfer icon disappears.

The radio control system can now be switched into Crane operation/Run mode by

entering the electronic On key (see section 8.4 on page 43):

– Hold the STOP button down.

– Push the LIFT joystick 3 times.

– Release the STOP button.

7.9.3 Logging-off all radio

transmitters

NOTE

If one or two of the pre-paired, inactive radio transmitters are in STOP mode,

the log-on status is enabled when the currently active radio transmitter is

switched off (either completely or put on Standby).

For this reason, all pre-paired radio transmitters that are not currently in use

should be completely switched off or they should be in charging mode.

For safety reasons, control can only be transferred to another pre-assigned

radio transmitter if it is in STOP mode.

The transfer icon is shown on the radio transmitter screen when the STOP button

is pressed following a power failure and after the DRC radio receiver is re-started.

This must be acknowledged with the HORN pushbutton. Normal work can then

resume.

All radio transmitters can be deleted from the DRC radio receiver:

– Hold the STOP button down.

– Press the F2 key 3 times.

– Hold the F1 key down until the screen changes.

– Release the STOP button.

– Press the F2 key.

An hourglass appears on the screen during the log-off process.

Following successful log-off, the screen shows:

Pre-paired radio transmitters can also be deleted by means of another non-

assigned radio transmitter. To do this, there must be no radio connection between

the DRC radio receiver to be disconnected and any other radio transmitter. This

can be done via parameter 000 in the radio transmitter parameter menu.

where you can either enter the crane ID or the DRC radio receiver serial no.

– Hold the STOP button down.

– Push the LIFT joystick.

– Push the LEFT joystick twice.

– Hold the LIFT button down for approx. 5 seconds.

– Release the LIFT joystick.

– Release the STOP button.

????

STOP

???

43603844.eps