User's Manual

31
211 338 44.indd / 081019
NOID
001:
000
Important Assignment of the crane ID described in the following for putting the
DRC radio receiver into operation is a safety-relevant process that
must only be performed by authorised specialist personnel.
After successful establishment of a radio connection between the DRC-MJ D3
hand-held transmitter and the DRC radio receiver, the crane identification specified
according to section 6.4.4 must be assigned to the radio receiver. As long as
the DRC radio receiver operates with code “NOID”, no movement commands
or special functions are output to the crane control system. (To check radio
transmission in this status, use the signal button.)
Activating the assignment
Assignment can be activated in STOP mode, Run mode or Standby mode.
– Hold the STOP button down.
– Push the LOWER joystick.
– Push the RIGHT joystick twice.
– Push the LOWER joystick for approx. 5 seconds until the screen changes.
– Release the LOWER joystick.
– Release the STOP button.
The following screen appears:
7.6.3 Assignment of crane ID/
number for the radio receiver
Note: Additional information can also be shown on the screen depending on
the type of crane control system.
The code no. of the displayed parameter is shown in the first main row.
For DRC-DR units, the first digit of the three-digit parameter number is always 0,
for DRC-MP units it is always 1.
The value of the parameter is shown in the second main row.
Selection of parameter 004 for the crane ID/number
• Right joystick increases the displayed code no.
• Left joystick decreases the displayed code no.
42694544.eps
43679444.eps