User's Manual

211 338 44.indd / 081019

When the specified preparation steps have been completed, put the radio control

system into operation by logging the DRC-MJ D3 hand-held transmitter onto the

DRC radio receiver of the crane to be controlled. Following this procedure, the

radio control system must be configured for the specific application.

The DRC radio receiver on the crane must be supplied with power, ready for

operation and within range of the DRC-MJ D3 hand-held transmitter.

When the unit is switched off, no icons appear on the screen, the LED is off.

1. Press the STOP button to switch the DRC-MJ D3 hand-held transmitter on.

2. STOP appears on the display.

7.5 Putting a radio control

system into operation

with a DRC-MJ D3

hand-held transmitter

7.5.1 Switching the hand-held

transmitter on

43678844.eps

Press 1 x

Red

The screen first shows the DEMAG logo. The DRC-MJ D3 hand-held transmitter

searches for an assigned DRC radio receiver. Before a DRC-MJ D3 hand-held

transmitter is put into operation for the first time, it has no DRC radio receiver

assigned to it. Therefore, the following is shown on the screen:

If the transmitter has already been assigned to a DRC radio receiver in the log-on

steps as described in section 7.6.2, the following will appear on the display:

NOID

STOP

???

In this case, continue commissioning with assignment of the crane ID, see section

7.6.3.

43605944.eps

K564

STOP

???

43605844.eps

NOTE

Additional information can also be shown on the screen of the DRC-MJ D3

hand-held transmitter depending on the type of DRC radio receiver.