User's Manual

211 338 44.indd / 081019

Every crane that is operated with wireless control must be identified by means of

an easily visible crane ID/number. Travel direction symbols on the crane and the

crab must match the directions of movement for the travel motions shown by the

buttons on the hand-held control unit.

The coding labels are used to show the crane ID on the crab or the crane. The

crane identification shown by the coding labels must be identical to the crane

identification shown on the screen of the DRC-MJ D3 hand-held transmitter.

6.4.4 Identification labels for the

crane installation

6.4.4.1 Coding labels

42056044.eps

Yellow segment

Part no. 895 640 44

Black background foil

Part no. 895 639 44

42658944.eps

Display of crane identification on the DRC-MJ D3 hand-held transmitter

Crane ID

The coding labels (150 x 150 mm) (black background foil + foil with numbers) must

be attached to the hoist unit in such a way that they are easily visible.

The required numbers 1 to 9 are created by removing the yellow segments.

6.4.3 Compatibility

DRC D3 generation units are not technically compatible with units from the previ-

ous DRC D2 or DRC D1 generation. This means that D3 generation transmitters

and receivers cannot be combined with D2 or D1 generation units.

43667044.eps

Can be combined with

DRC-DR D3 DRC-MP D3

CAN bus receiver

Transmitter Part no.: 711 333 45 773 794 44

DRC-MJ D3 773 760 44 OK OK