User's Manual

22
211 338 44.indd / 081019
Icons in the first main row
S3
Fault icon
The fault icon is displayed if there is a fault.
The fault code is displayed in the row below. If there are several faults at
the same time, the code displayed changes in cycles.
Overload icon
The overload icon is displayed if there is an overload. The load of the
selected crab(s) is also displayed in the row below if the hoist unit is
equipped with an overload protection device (e.g. ZMS, EOD).
Brake icon
The brake icon is displayed if the additional brake has been applied.
“Universal output 1 switching status” icon
This icon is displayed when universal output 1 is active. The function of
this output can be programmed.
“Universal output 2 switching status” icon
This icon is displayed when universal output 2 is active. The function of
this output can be programmed.
“Universal output 3 switching status” icon
This icon is displayed when universal output 3 is active. The function of
this output can be programmed.
“Important. Safety function de-activated” icon
This icon indicates that a function relevant for safety such as a reduced
load or by-pass control has been de-activated by the operator.
“Load reduction active” icon
The icon indicates that load reduction is active. Only a reduced load
(specified by a parameter) can be lifted when load reduction is active.
“Transfer” icon
The icon indicates that the transmitter is being connected to the selected
crane.
“Hourglass” icon
This icon is displayed during the log-off process.
“Snail” icon
This icon indicates that the crane is travelling at reduced maximum
speed (speed limit function).
The load-dependent bar display shows the load on the crane in five
increments of approx. 20%. This display is independent of the crab se-
lection and always refers to the maximum possible load.
Load-proportional bar display