Instruction Manual

I-1384 Page 3 of 16
Rev. -- 47069 8/23/2021
DC8410 Series
(larger pumps are not shown)
FEATURES
• Five Modes of operation
o Formula Select Mode – Each pump receives a trigger from the machine supply valves
and then performs the delay and dispensing as programmed. A trigger qualifying time
may be programmed to ignore short valve cycles.
o Push Button Mode – When the button on the front of the dispenser or the “start” button
on the VLR (Dairy Clean Remote, formula selector) is pressed, all pumps delay for a
programmed time and then dispense the programmed amount of chemical.
o Flex Trigger – This allows any pump to operated using any trigger. A pump can be
programmed to operate with multiple triggers.
o Sequence Mode – This allows the pumps to be triggered using the drain valve or similar
signal from a controller. It is possible to use the hot and cold fill valves as well.
o Relay Mode – This will cause the pumps to directly respond to trigger inputs.
• 9 Formula Capability
• Programming is performed on board at the control face of the system
• Load (run) counter for each formula
• Total load (run) count for all formulas
• Password protected programming
• Prewired for minimum installation time
• Quick-change squeeze tubes which require no tools
• Out of product alarms available